Can you do a video with the bolt cutting and engraving clear acrylic?
@angrygaragemechanic
Жыл бұрын
Nicely done 👍 How thick of wood and acrylic is this machine capable of cutting?
@HouseOfLasers
Жыл бұрын
At the moment I will say 1/8 up to 1/2 inch material depending. I did get through 3/4 but just because it can.... It might not be efficient or profitable.
@musicandthewalk
8 ай бұрын
Have you tried thicker ply's?
@Eagles25
Жыл бұрын
How long did it take to engrave and cut?
@HouseOfLasers
Жыл бұрын
I believe it was around 10=15mins 2000DPI is a lot of movements
Пікірлер: 7