In this video, I go over one way to set up full span ailerons on a Timber X and several other items that you might find useful. You must select the proper wing type, reassign the channels to the receiver ports, set up a combination switch and an aileron-to-flap mix, assign a switch to a channel for the receiver's flight modes, and configure SAFE Select. I also talk about rates, expo, servo travel, and control linkages. I forgot to mention that Horizon's BNF SAFE-Select receivers are already set up to go into loiter mode in failsafe mode. You shouldn't change anything in the failsafe settings menus.
- Күн бұрын
Timber X - Full Span Ailerons and AS3X/SAFE Setup
- Рет қаралды 1,156
Пікірлер