In this video i will go over how to replace a timing belt on a 2008 Toyota 4runner with a 4.7 liter v8. This will also apply to a Tundra and sequoia with the 2UZ-FE 4.7L.
Recommended tools:
Milwaukee electric impact: amzn.to/3DeYKSn
Milwaukee electric ratchet: amzn.to/3TNmi84
IR air impact: amzn.to/3Ubzymq
Box end wrench: amzn.to/3N8vAJd
Socket set: amzn.to/3ziYZe0
Coolant funnel: amzn.to/3DCelN8
Flashlight: amzn.to/3Nh6JTA
Hood light: amzn.to/3DcRrKU
Parts:
Timing belt kit: amzn.to/3N9DWA2
Coolant: amzn.to/3TVTjit
FIPG: amzn.to/3zmuAvm
As an Amazon Associate I earn from qualifying purchases
00.00-Introduction
00:48-Wheel removal and coolant draining
01:24-Remove fan shroud and intake
02:26-Remove hose and fan
05:45-Thermostat housing and top cam cover removal
09:51-Set timing before removal of belt
12:33-Remove fan bracket
14:06-Timing check and timing belt removal
16:17-Removing water pump assembly
18:30-Installing water pump and wire harness
20:32-Compressing tensioner
21:27-Checking all Timing marks and belt install
24:57-Checking Timing after one engine revolution
26:09-Installing lower cover and crank pully
28:37-Installing alternator, tensioner and power steering pump
30:56-Installing Thermostat housing
32:23-Installing oil cooler lines
33:40-Installing fan and shroud
37:36-Installing battery and verifying vehicle starts
#shoptimewithdrew #toyota #howto
Негізгі бет Автокөліктер мен көлік құралдары Timing belt replacement by a Toyota master tech
Пікірлер: 303