Damn I didn't realize how advanced this job is! Looks like I'll be going with a 4.0L 4th gen😢
@djlouis2150
4 күн бұрын
I was looking at your video I didn't realize that you didn't use any water pump casket maker ???? you use only the water pump casket
@AL_0401
5 ай бұрын
Money is tight right now for me so I’m going to attempt to do it myself. I hope I don’t screw it up😂
@SlimNubster
2 ай бұрын
Hey bro, how'd it turn out?
@christianbass7244
Ай бұрын
@@SlimNubsterit had to have blown up if bro hasn’t answered 😭😭
@SlimNubster
Ай бұрын
@@christianbass7244 mannn I've been assuming the worst. Lol
@SkillCollectors
Жыл бұрын
That crank pulley bolt was ON THERE.. phew
@marksimmons3801
2 ай бұрын
breaker bar 7/8 short socket and starter will break the crank bolt loose
@CesarsCarCorner
Жыл бұрын
When did 4Runner get a V8? It looks like the old 4.7L that came in the old Tundra! Great video!
@SkillCollectors
Жыл бұрын
That generation is when it started. It’s the exact same engine as the tundra and sequoia!
@carlosguzman7207
3 ай бұрын
That's the only 4runner came out v8 very good car
@joec6746
4 ай бұрын
Great video. I see the tools used but, do you have a list of part numbers for water pump, gasket, associated seals required....? Thanks
@Koala_z06
Жыл бұрын
Fly you out for a head swap and clutch install on a z06?
@SkillCollectors
Жыл бұрын
Yikes, no experience with that haha
@valtierrafamily8176
8 ай бұрын
Hey bro u didn’t have to rotate the crank pulley twice to verify ur timing marks because everything was on tdc?Just asking cause everyone always seems to turn it after they install the belt.
@SkillCollectors
8 ай бұрын
OEM belts have marks on the belts, if they all line up with the gears, it's in time. Toyota makes it really easy.
@ronaldo77782
Жыл бұрын
Why is important not to line up the timing marks to the T ?
@SkillCollectors
Жыл бұрын
Because those are not the proper timing marks for timing belt installation per the service manual. Not sure what those marks are to be honest. Someone mentioned they are ATDC marks (After Top Dead Center) but I don't know.
@ronaldo77782
Жыл бұрын
@kristofflutchman I did research it ,so after aligned all of the marks at TDC, they should be move to the T marks so it will be out of tension and prevent the belt to jump backwards.
Пікірлер: 22