Something else I learned is that the basket that comes with the machine can also cause bunching on longer cuts EG:F150 back windscreens. The film folds on itself & when it feeds back in for the cut it jams the machine because its doubled up. Hope that makes sense. Moral of the story get a litte table or just drop the basket on the ground. Thanks K.R
@pedroguzman8161
4 ай бұрын
What tape is that ?
@GoDetailerGo
Жыл бұрын
This saved my ass today. Rollers were not lined up. Also I cut through my strip during a bunching incident. So I just put tape on it.
@davidwhitley6856
Жыл бұрын
What kind of tape are you using?
@joshuamartin7443
2 жыл бұрын
When I order a new plotter I’m sending it to Kevin and have him set it up for me then pay him for his time, film use and to reship it to me lol
@onpointprostyles
2 жыл бұрын
Let’s get it! Lol
@joshuamartin7443
2 жыл бұрын
@@onpointprostyles or when I decide I’m ready to upgrade to a servo cutter I’ll order it and have it sitting here unboxed and put together ready to dial it in for when your passing through Louisiana. Save me on shipping and you can get a big thank you lunch while you here lol
@onpointprostyles
2 жыл бұрын
@@joshuamartin7443 I was skeptical until you mentioned food. Lol
@joshuamartin7443
2 жыл бұрын
@@onpointprostyles hahaha Get you some ol cajun food for you. Send you with what the oilfield workers called a Cajun care package lol
@rockhead4534
7 ай бұрын
What is the yellow tape for?
@user-ft3ro5my5p
Жыл бұрын
What if it cutting but it's not finishing the cut and there is about a 3inch gap. And when I got to install the measurements are off.
@ismaelayala4283
Жыл бұрын
I HAD THAT PROBLEM WITH MY NEW PLOTTER AFTER WATCHING SEVERAL VIDEOS I FIND OUT THAT I DID NOT REMOVE THE CLEAR TAPE OVER THE STRIP AND FOR SOME REASON THE BLADE CUT IT A LITTLE BIT AND THAT WAS CAUSING WHAT IS HAPPENING WITH YOURS,I DID REMOVE THE BAD CLEAR TAPE AND THAT WOULD SOLVE THE PROBLEM,IF YOUR SOFTWARE LETS YOU CALIBRATE CUTING A STRAIGHT LINE YOU WILL FIND OUT WHERE IS THE BAD SPOT ON YOUR STRIP,KEVIN HAVE ANOTHER VIDEIO WHERE HE EXPLAIN HOW TO CALIBRATE YOUR PLOTTER AND FIND OUT WATH IS YOUR PROBLEM,IF YOUR PLOTTER IS NEW IT WILL BE THE STRIP BUT IF YOUR PLOTTER IS LITTLE OLDER AND THE STRIP LOOKS GOOD PROBABLY IS TIME TO GET A NEW BLADE,GOOD LUCK
Пікірлер: 12