Tipco prides itself on its strict adherence to NAHAD and Hose Safety Institute guidelines. Take a closer look at our 11 step process for industrial hose fabrication.
1. Start by inspecting for any defects.
2. Expose the ground wire and check for continuity.
3. Measure the hose wall thickness and average the results.
4. Use HSI Manufacturer's crimp chart to determine the OD.
5. Insert the fittings and sleeves fully into the hose.
6. Get correct die and setting from HSI Manufacturer's die chart, insert proper dies and set up Variable Crimp machine.
7. Crimp the hose while following all safety procedures.
8. Check with the calipers to ensure that the crimp OD is within HSI manufacturer's tolerance.
9. Re-check the hose for grounding continuity again.
10. Measure to determine that hose is within length tolerance.
11. Visually inspect the hose per HIS recommendations.
Негізгі бет Tipco Technologies: Industrial Hose Assembly
Пікірлер: 6