Great work Chris. It's good to see you back on the tube posting vids again. Thank you for the plug, I really appreciate it mate. Looks like your TM25 is running sweet. Great looking parts you're producing too. Cheers Aaron
@chrisadesigns
9 жыл бұрын
thanks Aaron
@SmallShopConcepts
9 жыл бұрын
nice work! I love my closed loop steppers! glad you do too! what can software are you using? looks like you could go quite a bit more aggressive on you DOC on your profiling especially at that feed rate. line you said in the video you didn't have a finish pass, it if you wanted to go more aggressive on the roughing passes and run a finish pass you would have the same finish as now and reduce milling time by a large margin. what end mill were you using in that operation? Sounds like your Gibbs are a bit on the loose side, you can see the stacks of chips shaking around from vibrations and hear it in the cut. what did your backlash end up coming out at?
@chrisadesigns
9 жыл бұрын
the closed loop steppers are nice, I could certainly go more aggressive but the endmill I am using isn't that great in aluminum and any faster causes to much vibration, I need to get some aluminum specific endmill with the right geometry then I'll be sailing
@thompascoe8463
8 жыл бұрын
What happened to the website mate? ?
@chrisadesigns
8 жыл бұрын
+Thom Pascoe Short answer - Zero Interest. But I have more things coming to this channel, I figured I would just run the channel now, I have a few projects I am working on
Пікірлер: 6