Vav's in BMS that I've put in always operate on a 10"supply duct from a main looped trunk. Presure always there when it's called for. Thanx for this video. Keep up the great work..
@AERight462
5 жыл бұрын
Doubts cleared after this video. ...thanx alot
@nazeerahmed4649
8 жыл бұрын
Helped a lot. thanks
@josepenado6467
5 жыл бұрын
Thanks good info
@rajkumarnirlesh7496
3 жыл бұрын
Knowledgeable 👍
@sagittariusmax5419
2 жыл бұрын
how to contact you?
@TitusHVAC
2 жыл бұрын
please contact us at communications@titus-hvac.com
@sagittariusmax5419
2 жыл бұрын
@@TitusHVAC can i ask anything hvac? do u reply right away?
@TitusHVAC
2 жыл бұрын
@@sagittariusmax5419 We typically respond well depending upon the HVAC question, how can we assist?
@sagittariusmax5419
2 жыл бұрын
@@TitusHVAC a rooftop unit with multiple vavs serving a conference rooms. now when RTU tstat reaches its setpoint the RTU airflow reduce its airflow to minimum which affects the vav capacity and gets hot in the conference room. can a fan assists vav solves this issue?
@TitusHVAC
2 жыл бұрын
@@sagittariusmax5419 The thermostat for the RTU should be placed in a central location like a lobby or a hallway near a return grille. It often works best to use a remote sensing thermistor or RTD placed in a return duct, so the RTU can control based on return air temperature. The RTU should be set-up to keep the VAV terminal units supplied with adequate airflow and inlet pressure regardless of room loads in individual spaces being served.
Пікірлер: 13