Dino’s Tinker Shed, S3 Ep27, Today, I installed motorcycle brush guards.
In this episode, I walk you through how I installed new brush guards on my DR650, but you can follow these steps with most dual sport or adventure bikes with similar results. I used an inexpensive set of guards that cost only about $45.00 Canadian and they appear to be good quality however only time will tell.
I do talk about how to remove the factory grips on a DR as well as how to remove the locating pins on the bar controls to allow you to move them and here are links to those videos
Bar install:
• Installing new handleb...
Stock grip replacement:
• How to replace your mo...
As always, I have included time codes so you can skip around
00:00- Cold opening
00:44- Introduction
01:04- Overview
2:46- What am I installing?
06:02- Removing my grips
09:05- Re-locating the controls
09:56- Cutting your grips
12:29- Removing the old hand guards
16:16- Dry fitting the new guards
18:51- Lack of instructions and final fitting
20:47- Final thoughts
MUSIC:
Country Cue 1 by Audionautix is licensed under a Creative Commons Attribution 4.0 licence. creativecommons.org/licenses/...
Artist: audionautix.com/
For Mimi by Twin Musicom is licensed under a Creative Commons Attribution 4.0 licence. creativecommons.org/licenses/...
Artist: www.twinmusicom.org/
Негізгі бет Автокөліктер мен көлік құралдары Today, I installed motorcycle brush guards on my dual sport.
Пікірлер: 52