Bro pls make a vedio about x- off option in weld scan and lamination how to consider..and it's use
@alalndt8041
3 жыл бұрын
Ok bro thanks you
@ruhanhossain9061
3 жыл бұрын
🤔🤔🤔🤔🤔🤔🤔🤔🙂🙂🙂
@bacelismael8687
3 жыл бұрын
Nice video, thanks bro!. There's another way specific to sonatest D-50, which is by using Angle measure mode in the meas menu. Default values are already 15mm for depth, and 3mm for hole size. You only need to calibrate your range accurately and make the thickness bigger than 15mm in Trig menu. Good luck and thanks for your efforts :).
Pls share with your friends bro my Ndt KZitem channel thanks you very much bro
@bacelismael8687
3 жыл бұрын
It's ok, calibration blocks might differ a little bit, mine has 3mm hole, no problem you can enter whatever real dimensions of your cal block and it'll work just fine. Thank you again for your great work and videos 👍🏻.
@mattthrower8674
3 жыл бұрын
Nice method, however why not just use the perspex disc and the engraved numbers on the calibration block. Always good to know more than one way though 👍
@alalndt8041
3 жыл бұрын
Thanks you very much bro
@alalndt8041
3 жыл бұрын
Pls share with your friends bro my Ndt KZitem channel bro
@nurailshaikh3860
3 жыл бұрын
Bro depth devide bp then cos-inverse But depth is ....whatever your machine showing not 15 ..... But one thing angel checking time how much thk is put your machine? I thing 15 mm thk put is currect because sdh depth is 15 mm
@allwinthivan6795
Жыл бұрын
How to true prope angle checking v2 block please one video sir.
@alalndt8041
Жыл бұрын
This video already I make you check there have brother
@alalndt8041
Жыл бұрын
Sorry I make v1 block
@durgeshkumarsingh1518
11 ай бұрын
Alal bro Could you make 1vedio how to find true angle on v2 block. along with how to check SNR also. Plese if you have vedio send to me
Пікірлер: 22