Mr IQ remember safety first. Get a push stick. Your hands will thank you for it. And use a blade guard.
@mr.IQhomemadeDIY
7 ай бұрын
Hello. I always use a saw guard and push rods. This is only for the video, I worked without protection, so that it would be better visible to the audience. Thank you for the tip.
@meghrajbilwani2526
2 ай бұрын
Absolute genius....thank you.
@mr.IQhomemadeDIY
2 ай бұрын
Thank you very much for your comment 👍👍👍👍👍
@meghrajbilwani2526
2 ай бұрын
@@mr.IQhomemadeDIY Your channel is aptly named. You have a high IQ 👍. Where are you located? I would like to learn from you.
@StevenSiddle-t3p
7 ай бұрын
That's not really cutting it without chipping! It's cutting it with chips then removing the chips with a router. You'd have to cut all the pieces longer than you need then rout them to the right size.
@mr.IQhomemadeDIY
7 ай бұрын
Yes I know. Thank you for your comment
@eiosopaolo
6 ай бұрын
Hi, nice videos, but in this one: how much material is removed with the milling of the third method? (2mm?)
@mr.IQhomemadeDIY
6 ай бұрын
Hi. 1mm. But if the saw is not sharp, then 2 mm.
@evandroschuler2159
7 ай бұрын
Coloque fita crepe e depois execute o corte. Fica resolvido
@mr.IQhomemadeDIY
7 ай бұрын
Hello. Thank you for your comment
@bennamingismyname
7 ай бұрын
Why do you have to stack it? Isn't it the same as lowering the blade??????
@mr.IQhomemadeDIY
7 ай бұрын
Yes, it's almost the same. But if the saw does not go down, then this is a good way to get rid of chips
@bennamingismyname
7 ай бұрын
@@mr.IQhomemadeDIY I see. It couldn't be adjusted?
Пікірлер: 21