That's a decent snowblower, but for dealing with that type of snow, Ariens snowblowers are better at handling it.
@MI_Magazine
8 ай бұрын
Agreed, Ariens is a solid blower and have neighbors who have them.
@spartanj2957
8 ай бұрын
There is a vid on the tube that explains how to fix your problem with auger lever ,it's a simple easy fix.
@MI_Magazine
8 ай бұрын
Thank you.
@TimStout71
8 ай бұрын
slow the speed down, you are putting a lot of stress on the belts, engine and slip disk.
@MI_Magazine
8 ай бұрын
Thanks, will do.
@robertknight4672
8 ай бұрын
I wish they would put a sticker on new machines telling you exactly what type of snow each speed is good for. I have an old Murray built Craftsman that actually has that information right on it. 5 and 6 are just listed as transport speeds. I believe that machine says I can go up to Gear 3 and light snow but I typically don't go past number two regardless of snow type.
@MI_Magazine
8 ай бұрын
@@robertknight4672 I agree. Or they could at least put conspicuously in the manual. Great suggestions. Very useful for me to know. And sure the others will benefit too. Cheers!
@MrBen527
8 ай бұрын
Yeah, I don't even move the speed control on my 824.
@MI_Magazine
8 ай бұрын
@@MrBen527 Thanks. Great tip.
@baddad5781
7 ай бұрын
Nice machine. My thinking is how is the levers on the under side of the dash put together? Are the under side connections to the dash all plastic? If so lightly grease all pivot points under the dash and be very gentle with those controls changing gears and engaging the drives.
@baddad5781
7 ай бұрын
Also my friend grease your wheel shafts or coat antiseize on them and also lightly grease the sliding shaft, the sprocket gears if there is any and side bushings and everything in the blower bottom to prevent them from rusting and seizing onto the shafts. Thanks for the demo.
@baddad5781
7 ай бұрын
Clean grease and grim off of the friction plate also.
@MI_Magazine
7 ай бұрын
Thanks. If you get it shipped in a box, the lever cables need to be installed and the traction control rod. Yes, grease may help there.
@MI_Magazine
7 ай бұрын
Glad you liked the demo.
@chooisc5297
8 ай бұрын
Get the toro e26 battery version for a gas vs. Battery review 😋
@MI_Magazine
8 ай бұрын
Was tempted to go with the e26. But was not able to get a read on battery performance over the next couple of years of use. Certainly, with new batteries, expect that the e26 will be formidable.
@cbielman1
8 ай бұрын
@@MI_Magazine I wouldn't want the battery version. Batteries have a shelf life, gotta keep it happy over the summer with a trickle charge. You would always be starting it cold in the garage, and would have easy access to a power source. Can't imagine it'd be much work to pull start from the bottom of the driveway if you ever powered down for fuel or whatever. I'm sure it'd pull start easily when warmed up.
@MI_Magazine
8 ай бұрын
@@cbielman1 Agree, for something like a winter storm, you also don't want to be at the mercy of batteries.
@mattheweveleigh6351
8 ай бұрын
Nice garage floor, does snow leave stains on your expoxy floor?
@MI_Magazine
8 ай бұрын
Floors clean easy. Whether it's the melted slush from the road that the cars bring in or the rusty marks from the snowblower, you can get rid of them with a splash of water or a mild floor cleaner. Looks like new post winter.
@mattheweveleigh6351
8 ай бұрын
@@MI_Magazine ok thanks for your message back, I’m planning on getting my garage done sometime this year…
@shanew7361
8 ай бұрын
Did they resolve the handle issue if so, what was the issue?
@rbflantry8655
8 ай бұрын
I believe that company's do not put a lock on the auger lever for insurance issues with people losing fingers, the lock mechanism is located on the drive lever. You should try engaging the auger, then engage the drive...when you let go of drive lever while holding down the auger lever, it should stay moving forward, freeing up your left hand to move auger shoot
@shanew7361
8 ай бұрын
@@rbflantry8655 Makes sense, thanks!
@MI_Magazine
8 ай бұрын
Unfortunately, not yet had a chance to call. Will update here when I get it resolved.
@MI_Magazine
8 ай бұрын
@@rbflantry8655 Should be the other way - when you hold down the drive lever, followed by the auger lever, the latter should stay locked. Drive lever must be pressed down to operate. If you let go of the drive lever, the auger lever is now unlocked. In my case the auger lever does not stay locked down, I need to keep both pressed to operate.
@JessicaSimonson1976
8 ай бұрын
Mine is brand new 2024 same way. I think just a safety feature.
@paulcondie2520
8 ай бұрын
Put an impeller kit on it, it'll throw 50' and blow the wettest of snow, will never clog! Will damn near pump water!
@MI_Magazine
8 ай бұрын
@paulcondie2520, thanks for the tip. Just looked it up. Sounds interesting yet inexpensive. Good mini project for next summer. Cheers!
@paulcondie2520
8 ай бұрын
@@MI_Magazine absolutely! You'll be impressed, trust me. I have other snow removal guys approach me and ask all the time. The first time I used my blower it was wet and had one hellova time. I searched on the tube and found this . It's been 10 years after the install and hasn't clogged since
@MrBen527
8 ай бұрын
These newer models don't clog. I have the exact one, and I don't believe they make a kit for them either.
@paulcondie2520
8 ай бұрын
@@MrBen527I believe you are wrong, search it. There's a forum that states otherwise, if it has an impeller and there's a gap between the impeller and the impeller housing then it'll clog and you can put a kit on it.
@paulcondie2520
8 ай бұрын
@@MrBen527and you would be wrong. Plenty of forums that state otherwise
@andrewdayton6908
8 ай бұрын
Good review
@MI_Magazine
8 ай бұрын
Thank you!
@tiredoldman5329
7 ай бұрын
Is there supposed to be a braking system on this thing? I let go of the handles, turned around and it rolled away down my driveway.
@MI_Magazine
7 ай бұрын
It should stop when you let go of the drive handle. Was that stuck down? If so, may be a fault.
@tiredoldman5329
7 ай бұрын
@@MI_Magazine No, it's not stuck down. Auger lock doesn't work either. 1 day old.
@PainterD54
4 ай бұрын
Brand new machine? Did he even break it in before going full bore thru the wet heavy snow? WTF? So he's really impressed on how far it blows snow? It's fricken brand new! My 35 year old Toro will blow snow that far.
@MI_Magazine
4 ай бұрын
Thanks for watching.
@zavomika8306
8 ай бұрын
Return the toro and get 1 stage honda hs720
@MI_Magazine
8 ай бұрын
May be too late now but will look into the Honda 720.
@jamesorsby7553
8 ай бұрын
Why would he trade in a Toro dual stage machine to get a single stage? That's ridiculous.
@jpmergenhagen6655
8 ай бұрын
Word to the wise DONT SHUT OFF THE MACHINE IDLE IT DOWN FOR A MINUTE THEN SHUT OFF.
@MI_Magazine
7 ай бұрын
Thank you.
@arvestrandsphotography
12 күн бұрын
15 minutes and still not started the machine.....
@MI_Magazine
11 күн бұрын
Thanks for sticking around through the first 15 minutes! We will try to make these parts more user friendly for people at your level in the future.
@derrickgibson4004
8 ай бұрын
No clue what he's doing lol
@MI_Magazine
8 ай бұрын
Glad you stopped by. Learning along and sharing the journey with anyone interested.
@stevenmiddagh6265
8 ай бұрын
This guy has no clue what the hell he is doing
@MI_Magazine
8 ай бұрын
Your deep insights are noted. In 50 odd years of life experience, reflecting on top achievements that make me proud, I've always encountered individuals who prefer criticism over encouragement. It's a common challenge for content creators who are trying to help others gain perspectives on products. This is validation that we are on to something worthwhile. Meanwhile, we'll strive to make our content more beginner-friendly, for people at your level. Thank you for your feedback.
@cbielman1
8 ай бұрын
Don't understand the criticism. You didn't portray yourself as a Toro engineer. You gave a presentation from a smart person who's not an expert. That's the way us other smart people would be learning it as well. I commend you on the discussion of the wheel locks. I wasn't understanding where you were going at first. I just received mine from a store already assembled. I suspect it's on free rolling mode because I rolled it into the garage with ease. I would have been very confused and likely spent some time trying to figure the solution. Nice work!
@stevenmiddagh6265
8 ай бұрын
@@cbielman1 the machine comes with a owners manual. He should of read it before he tried to make the video. That is why I made the comment. Plus you don't have to be a rocket scientist to operate a damn snow blower. Common sense goes a long way and apparently this guy doesn't have any.
@cbielman1
8 ай бұрын
@@stevenmiddagh6265 In my case I didn't get an owners manual. Came new from an auction site. So I gleened the basics from the video.
@MI_Magazine
8 ай бұрын
@@cbielman1 Thanks for the nice words. Cheers and happy snow blowing.
Пікірлер: 66