Your Jeep Patriot videos have saved me hundreds, if not thousands of dollars on my own Patriot. I so appreciate the time you take to record and share your knowledge. Cheers from Michigan.
@pablosalinas2903
Жыл бұрын
Excellent video it helped me a lot!🤝🙏👏👏
@idb2b
Жыл бұрын
Thank you for making this video! 🍻
@robertboicourt7670
7 ай бұрын
thank you very much for the info.
@MrEisnbauna
5 ай бұрын
Very good explanation!
@xardashks7346
23 күн бұрын
Hi,i have a jeep compass 2.0 crd 2007 and when i start the car yesterday come the light indicator of abs,src,bas,4wd,traction control,electronic trottle control...all this error and the car run now just with front drive wheel(have just front traction)...can be the TIPM fail and make this all problem???? Thank s and sorry for my english
@mtlcarguy
22 күн бұрын
I don't know, but you can look at my video about ABS light on. link: kzitem.info/news/bejne/po6pnJiJr4J0iJg
@stanimirpavlov
8 ай бұрын
Do you know if the same TIPM is used on Jeep Patriot 2010 equipped with Diesel and Gasoline Engines or they have different (incompatible) TIPMs? TIPMs from diesel engines are more easily found here but I want to put it on a car with gasoline engine.
@mtlcarguy
8 ай бұрын
I don't know! I have never seen any Jeep Patriot with a diesel engine in Canada. Some gasoline engine TIPMs should be interchange if the part number is the same or the superseding part number is compatible with the transmitted data, the data bus network communication protocols and the LIN bus communication version and the LIN data. Ask to a service person at your local Jeep dealership, he should know more about it.
@veraninja4304
Ай бұрын
Where is the fuel pump fuse ???
@mtlcarguy
Ай бұрын
There is no specific fuse used to directly protect or turn OFF the Fuel Pump Module. The fuel management is done by the TIPM electronic fuel pump control system.
@abiolamuhammed5843
8 ай бұрын
can a defective TIPM cause loss of communication to all modules
@mtlcarguy
8 ай бұрын
YES if one or more specific electronic component(s) of the circuit board(s) is/are defective.
@romulopalmeiraromulo4334
4 ай бұрын
Anyone know Whats the fuse Of auxiliar headlights?
@romulopalmeiraromulo4334
4 ай бұрын
Mile lighthhouse*
@mtlcarguy
4 ай бұрын
If you mean fog lights, there is no specific dedicated fuse. The output power comes from the TIPM C11 connector. You can try the fuse 31(Headlamp Washer Relay Control) or the fuse 36 (Headlamp/Washer Control/Smart Glass) or ask your local Jeep dealer service person.
@jovictor3007
Жыл бұрын
Hello, where is your garage located ? I have electrical issues on a jeep compass, no power from tipm to starter.
@mtlcarguy
Жыл бұрын
I am retired and I only repair some vehicles to help my close family. Note, even if your TIPM is in good condition, the starter will not work if a relay located in the fuse block (relay box) is corroded or defective.
@jovictor3007
Жыл бұрын
@@mtlcarguy I verified all relays and fuses there are three for fans and one main relay it is a jeep compass 2007 , according to the electric diagram power goes from tipm straight to the starter on c 10 yellow gray cable however the relay box had a lot of collosion as a matter of fact one relay for fans broke inside and it didnt bother me until now that the car is in a no start no crank
@jovictor3007
Жыл бұрын
@@mtlcarguy Can you recommend a good trustworthy electric Garage in Montreal I can take my car to ?
@jovictor3007
Жыл бұрын
I was told to verify input on a c7 B+ from ignition red yellow orange cable to tipm , that is why I viewed this video , the diagram seems different and I have more connectors than what is shown in this video, i cant figure out what is what , 1,2,3,4,5,....13 they are numbered abcdef at this point I need to get it to a professional ,I will not mess with it anymore.
@mtlcarguy
Жыл бұрын
@@jovictor3007 If your Jeep Compass is not the second-generation (MP/552), the C7 TIPM connector is connected with the FUSED ignition switch output via the pin no 5 (Run-Start), the pin no 7 (Run), the pin no19 (Run-Acc) and the ignition switch output pin no 21 (Run-Acc). This C7 connector has also 11 pins connected with fused B(+) wires.
@telefonetoca
3 ай бұрын
Lookiy for power window
@mtlcarguy
3 ай бұрын
A good bidirectional scan tool is required to troubleshoot the window regulator modules if it is an electronic or electrical problem. This kind of work is usually done by a specialist.
Пікірлер: 30