This is the absolute best 5th gen oil change video that I have seen. Please do other videos! Transmission fluid change would be awesome!
@mtnslyr
10 ай бұрын
Finally a video with clearly labeled parts, tools, and bolts. Thank you.
@a10sim
10 ай бұрын
As others have mentioned, finally a video which clearly shows and numbers the skid plate fasteners. Outstanding! Thank you!
@TediKay
Ай бұрын
Thanks for the Fab Tutorial. I found it easier to just remove that plastic splash guard on the front. 3 screws and it was much easier to install skid plate. Also, my plate would not remove unless I removed it. No amount of pushing it forward was going to unlatch it. That plastic guard was just in the way. Lastly, it took a 3' breaker bar to get my filter cartridge loose. That convinced me ti never take it to a dealer again.
@eph3-19
Жыл бұрын
perfect explanation video. No extra nonsense about metal filter housings.
@tommisera3816
10 ай бұрын
Yeah, this is the first 4 runner oil change where they didn’t want to switch out the plastic filter housing. Great video.
@khoi_tran
6 ай бұрын
Just the steps and the facts, no unnecessary fluff to lengthen the video. Please do more 4runner videos. Diff fluid, radiator flush, trans fluid:)
@jmac13131
2 ай бұрын
Recently purchased a 2012 SR5 and changed mine for the first time yesterday. Wasn’t too difficult except that I could not remove the skid plate completely so I just left it hanging and had to struggle to get to the filter from the behind the passenger side tire area. I was dreading the potential that the filter would be overnighted but it wasn’t so no issue there. I did notice that there wasn’t a washer on the drain plug of the oil pan so I added a blue nylon washer to be on the safe side. I 100% agree about the difficulty of checking the dip stick. It was already difficult with used oil (around 2k miles on what I changed) but was almost impossible to tell with fresh oil. I finished a little after dark and like you, I had to recheck this morning. Maybe I’ll have better luck with the skid plate next time. I plan to do it again in 2k miles as this was just to flush the oil that was in it when I purchased it since I wasn’t sure what the dealer was running in it. I had just enough Kirkland oil to use for this change but plan to go to Pennzoil Platinum High Mileage since I’m at 108k miles. At 110k my plan is to change every 5k so the nice round numbers will help remind me.😊
@manlioirula7650
Жыл бұрын
Outstanding instructional video, thank you
@HuskyMike
Жыл бұрын
Good video. One thing to note: the special nipple adapter that drains the filter cartridge will remove the small o-ring automatically when you remove the nipple.
@Thankyou_3
23 күн бұрын
But if you take the small oring out first, the plastic nipple will snap easily.
@spoilt-226
Жыл бұрын
Excellent video. Thank you so much. Question. 64mm oil wrench… where did you get yours ?
@SakibLH44
10 ай бұрын
WOW. Absolutely BEST oil change vid on the 4runner. Thank you so much.
@ghenadieodagiu2909
Жыл бұрын
Very informative. I wish I'd see your video first and place the rubber ring in the right place from the first time. Thank you!
@Nunyobidne55
9 ай бұрын
I’m in a red pro….but man…this trim look so goood!
@theirthereandtheyre2947
Жыл бұрын
Baxter adapter, after market skid plate and Fumoto valve. The factory design is overly complicated and the plastic filter housing will crack when over torqued by the dealership. Do yourself a favor.
@Puttj
2 ай бұрын
No crush washer on drain bolt?
@curtisjordan9210
Ай бұрын
Always pre-fill. Well done sir.
@Carlos72797
Ай бұрын
On my ‘22 TRD Off Road I removed the plastic part between the skid plate and the bumper cover. Without doing this I could not see the holes that the hinge tabs fit into. Watching many videos, there are many different skid plate configurations.
@ryanperreault4848
3 ай бұрын
Watched 5 to 6 different 5th gen 4runner oil change videos and this one was by far the most clear, concise, accurate video. Perfect for extreme OCD people like me!
@jontwibell2467
9 ай бұрын
This is a fantastic tutorial!
@timothytacner4865
Ай бұрын
I agree with the next guy. No extra aftermarket confusion, just straight to the point oil change.
@mackerelvelli
20 күн бұрын
Best ever! I came here just to see how you removed the skid plate! Mine is problematic to remove and I've been doing the oil changes with the plate dropped down hanging. It's not fun removing the oil filter housing with the plate in the way!
@ruckinehround6965
5 ай бұрын
Skid plate was the hardest part…… question did you have much metal….my 23. At 700 km I had lots of metal.
@michaelgoldstein5506
2 ай бұрын
Great, clear instruction. I'd probably run the engine to check for leaks before installing the skid plate though.
@HockeyDad81
2 ай бұрын
Great video..Thank you for showing how to change the oil for the 5th Gen. 4runner..
@therealmorganfreeman2875
5 ай бұрын
So how do you know exactly how much torque is being added when tightening?
@jetman1979
3 ай бұрын
What about that clip on the oil filter housing? I think that locks the housing down. Is this correct?
@1grfe
5 ай бұрын
The foremost front skid is 2, 10mm bolt using 10mm socket and clip, just to mention
@1grfe
5 ай бұрын
2:23
@ryanperreault4848
3 ай бұрын
Laying on the floor in my garage as I’m typing this and just discovered this too. 12mm is too big for the first 2 bolts on skid plate. 2024 SR5 premium here
@dad0041
Ай бұрын
Can you provide a link for the oil filter wrench? I was looking at one that had "teeth" in it.
@HiwaymanKS
28 күн бұрын
I am guessing you are listing the torque in inch pounds and not foot pounds,
@frankv64
2 ай бұрын
It would be nice if Toyota put a big enough opening to get to the oil filter too without having to take that monster off every time
@WookieLove1
11 ай бұрын
Thanks so much for the torque specs
@Runner-k8j
7 ай бұрын
Is perfect but I’m only used 6 q oil never more
@jeannerayman7392
Ай бұрын
I know I can do the research opinions full synthetic? And how much do you typically spend changing yourself? Where do you take your used oil
@markseifert-g9h
8 күн бұрын
Full synthetic. Can take used oil to local recycling centers or most auto parts stores for no charge
@sean-sk
2 ай бұрын
quick, to-the-point no BS explanation. I have already changed my new 4R oil once before but wanted a refresher before doing it again today. thank you
@sn4kebyte44
4 ай бұрын
Thae best ever tutorial! Very detailed. Thanks for putting a lot of work into this video. Helped me a lot! Keep them coming!
@nolife7851
7 ай бұрын
Easiest tutorial I’ve seen. Thank you. But did you only jack the passenger side?
@rositahl
7 ай бұрын
If I don't do any off road driving, I am wondering if it's best to just remove the skid plate and not put it back on? I also do oil changes very frequently like every 3K miles so it will save me some time.
@allenellis2329
Ай бұрын
Thank you very much!!
@goway9999
Жыл бұрын
Always great videos.
@markbenavidez356
Жыл бұрын
Thanks Joe!
@drywinddotnet
2 ай бұрын
Your vid is the absolute best 4Runner oil change vid. Soo many poor ones out there from some big channels.
@mlb3229
5 ай бұрын
I wish I saw this video first..
@youssbaraki
6 ай бұрын
Do you have a video on transmission fluid change for the 5th gen 4runner? Can you do one in case you don't have one?
@AFDL17
Жыл бұрын
Don't forget to install a new crush washer on the oil pan drain plug!
@markbenavidez356
Жыл бұрын
I’ve always reused the washer it comes with without any leaks
@raymondpecoraro254
Жыл бұрын
Just one thing You didn't mention replacing the crush washer. Other then that, excellent video. One more thing, I have a TRD skid plate. Pretty heavy, two people may be needed.
@frankv64
2 ай бұрын
He doesn’t have to change it. The fumoto valve stays always on
@willieetcheto5211
Ай бұрын
Awesome vid!
@jp8612
5 ай бұрын
just a little heads up but what you're calling the oil ratchet wrench is actually a breaker bar and it meant to break bolts that are torqued high like tire lugnuts. i don't suggest using it to tighten a nut or bolt but using a torque wrench or a regular ratchet.
@mauriciohenao6590
3 ай бұрын
Thank you
@MrLuiedr
Жыл бұрын
Super helpful vid!
@joking6052
7 ай бұрын
Wow, this is the best tutorial on 4Runner oil change and re-set. Congrats.
@andresbarajas4541
10 ай бұрын
Sir we're can I purchase the radiator botttom push clips
@rodneyjennings4304
3 ай бұрын
Thanks for this video. Possibly the best I've seen.
@dtrn750
Жыл бұрын
Great tutorial 👍🏽 but how do you reset the dash on a 2018 runner?
@astonebrook91
10 ай бұрын
When did you do the 1st oil change? I noticed you have a little over 5k on the obo
@truckingpower7332
6 ай бұрын
Gracias muy bien explicado
@darrinvandemark4781
10 ай бұрын
Forgot to mention the crush washer for the oil plug.
@RabiulIslam-fd3zp
11 ай бұрын
The best video. Thank you so very much.
@Tony-iv9sl
Жыл бұрын
thank you for clear stable video
@shay-hulud
6 ай бұрын
Thanks this was really easy to follow
@robertippoliti5186
5 ай бұрын
very informative and to the point
@rickfrei6016
Жыл бұрын
Excellent tutorial! Thanks!
@johncapps5044
3 ай бұрын
Perfect! Well done brother.
@brassferret7511
7 ай бұрын
It's already been said by others, but VERY nicely done! Many thanks for this video.
@777AOG
Жыл бұрын
Great video, thank you!
@billricheter5678
9 ай бұрын
Toyotas are a pain.
@GuntherEagleman
Жыл бұрын
very helpful
@darrinvandemark4781
10 ай бұрын
Did you remove the air dam in front prior? My 23 Limited has the air dam that makes removing the push clip a pain. The push clip is under the air dam but your video doesnt show it. Is it an exclusive thing for just limiteds?
@mtnslyr
10 ай бұрын
Yes, it is limited exclusive also sr5 sports. They both have front bumpers that drop low so need air dams.
Пікірлер: 75