Saw this and had the same issue with my 2014 corolla ,went to Lowes hardware and got the WD-40 Specialist Water Resistant Silicone Lubricant and sprayed the lower control arm big bushing in the parking area of the hardware , noise went away asap , its strange Toyota doesn't have a recall for these bushings .
@ALI_FIX12
Жыл бұрын
yas sir its not perfect car... thank you for watching ❤️👍🏻🔧
@Raptor200637
3 ай бұрын
Any mechanic working with flip flops has my respect.
@marcusangeles7782
2 ай бұрын
I work on cars with flip flops and shorts because it’s hot
@franks8327
9 ай бұрын
Love the speed of your videos. Short and sweet.
@ALI_FIX12
9 ай бұрын
you welcome sir ... thank you for watching ... do not forget to subscribe to my channel ❤️🔧👍🏻
@dr.thunder5014
Жыл бұрын
Thank you so much now I feel confident I can do this! One question for you, why did you replace the whole control arm? Was it because of bad bushings? Why not just change the bushings only?
@ALI_FIX12
Жыл бұрын
Thank you for watching...There is a warp in the control arm...it cannot be repaired
@leonelmaldonadobelasquez2243
3 ай бұрын
Grasias Maestro por el video
@ALI_FIX12
3 ай бұрын
you welcome ❤️🔧👍🏼
@danthemanium
Жыл бұрын
Great video mate
@ALI_FIX12
Жыл бұрын
thank you mate ... you welcom 🙏❤️👍🏻🔧
@godolforoderous3773
Жыл бұрын
Do you have to disassemble the ty rod when replacing the control arm?
@ALI_FIX12
Жыл бұрын
Yes sir....that way it will be easier to work ... thank you for watching 🔧❤️👍🏻
@noormohaidat1511
Жыл бұрын
Good job brother easy quick and pro
@ALI_FIX12
Жыл бұрын
you welcom sir ... thank you for watching 👍🏼🙏❤️
@jl4183
4 ай бұрын
You’re a life savior Subbed
@ALI_FIX12
4 ай бұрын
you welcome 👍🏼🔧
@jaredweicherding8907
6 ай бұрын
Did you loosen the subframe or lift the motor to get the clearance for the front facing bolts past the oil pan? I guessing based on the bags under the motor you loosened the motor mounts and lifted the motor a little bit?
@ALI_FIX12
6 ай бұрын
yas sir i lift motor ... thank you for watching ... do not forget to subscribe to my channel ❤️🔧👍🏻
@CleranceElva
7 ай бұрын
Do you know what size the bolts are to the control arm?
@ALI_FIX12
7 ай бұрын
19 ... 17 👍🏻🔧
@JuanReyes-ek2du
Жыл бұрын
How about the lower control arm bolt that has the oilfilter housing in the way,do you remove the housing to get bolt out,.or motor mount and lift up motor
@ALI_FIX12
Жыл бұрын
sorry sir ... but in this car we dont have lower and upper control arm !!!? ... we have only one control arm !!!
@Sheesh800
6 ай бұрын
What’s the part that was holding the part you changed ? I’ve been looking at diagrams but idk which one is it lol
@ALI_FIX12
6 ай бұрын
you mean subframe !!
@Sheesh800
6 ай бұрын
@@ALI_FIX12yes thank you!
@JustHelpMeOuT5466
Жыл бұрын
Everything is torqued to spec ezpz :)
@ALI_FIX12
Жыл бұрын
thank you sir
@saeen6286
6 ай бұрын
Does it need alignment after repalcing the bushings?
@ALI_FIX12
6 ай бұрын
yas sir you need 👍🏻🔧
@saeen6286
6 ай бұрын
@@ALI_FIX12 thanks Ali
@ALI_FIX12
6 ай бұрын
you welcome 🫡❤️
@BestAdjusters
7 ай бұрын
My girlfriends car is making a noise when turning to each side a small sound like a clank. Would it be this?
@dannydirt5D
7 ай бұрын
ye it could, check the ball joint for easy movement or a ripped rubber boot
@ALI_FIX12
7 ай бұрын
maybe cv axle or ball joint or tie rod end ... sorry i cant know if i not check out the car 😔
@kusitinasimo7122
8 ай бұрын
Pop mmm
@ALI_FIX12
8 ай бұрын
you welcome sir ... thank you for watching ... do not forget to subscribe to my channel ❤️🔧👍🏻
Пікірлер: 38