If you are looking for the most complete Toyota 4Runner and Tacoma Pickup gear install then this is the video for you. Stating with a 2005 Tacoma SD20B 8" Clamshell front with an open carrier, then a rear T100 8.4" rear with a mechanical locker. Then the diffs out of a mid 90's 4Runner starting with the rear TV6 with factory E Locker, and finishing things up by installing an Air Locker into the Toyota 7.5" SD19A Clamshell.
Pinion Depth, Backlash and rotational load is shown and explained using shims, adjuster nuts, crush sleeves and solid spacers.
Tools mentioned in this video
Pinion depth Checking Tool
www.randysworldwide.com/shop/yt-d02
Yukon Bench Buddy
www.randysworldwide.com/shop/yt-bb01
Yukon Clamshell Bearing Puller Kit
www.randysworldwide.com/shop/...
Big Tire Garage Merch
bigtiregarage.myshopify.com/
Where to get the goods:
Get Your building at: miracletruss.com/
Get This guy to build it: www.qualitybuilderstn.com/
Welders: esab.com/us/nam_en/
Plasma Table: www.fastcutcnc.com/
Fab Files: www.diyoffroad.com/
#fabrication #offroad #howto
Follow me on social
IG: / ianfrombigtiregarage
FB: / iansbigtiregarage
DISCLAIMER: Due to factors out of the control of the Big Tire Garage, we cannot guarantee against improper use or unauthorized modifications of this information. Big Tire Garage assumes no liability or responsibility for property damages or injury incurred as a result of any information contained in this video. Use this information at your own risk. Big Tire Garage recommends safe practices when working on vehicles and/or with tools seen in this video. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Big Tire Garage
Негізгі бет Toyota Gear Install, IFS and Rear Drop Out How To
No video
Пікірлер: 159