I really like the amount of detail you put into this video. You covered the abs sensor fix through multiple directions. It was also nice to see the scanner in operation. Thanks for the video.
@frankensteinrules6511
Жыл бұрын
Liked and subscribed. Thanks for explaining in a way that a 71 year old can understand, unlike Scanner Danner. I just replaced rack and pinion bushing on wife's Toyota Sienna, wish you had a video on that. It took me 5 days, but it takes me a while to get up off the ground. Look forward to more of your videos.
@williamblack7268
2 жыл бұрын
You do an excellent job of covering every posibility, colossal video!
@philh9238
3 жыл бұрын
Good work on your videos. Nice to see someone diagnose instead of pull codes and replace
@lifewithcarmel5444
3 жыл бұрын
Showing here daddy Toyota is a good car people here in my country prefer to use Toyota brand .This content is very informative keep sharing here more uploads to wait.
@partsshooter
3 жыл бұрын
Hey mommy.... This brand is reputable
@lifewithcarmel5444
3 жыл бұрын
@@partsshooter true that daddy here it is more recommended to use.
@ynasra1065
2 жыл бұрын
i changed my cv axle on 07 sienna and now i have speed sensor error p500 .......when i inserted the axle into the wheel bearing side i was pushing on the abs sensor ...not sure where is the problem now.........i think it is in the abs area ..... i did my axle twice because autozone axle is not a fit the pin doesnt fit on az ones,nomore az parts for me
@ask43242flight
2 жыл бұрын
Very good tutorial! When you tested the 3V from the female abs adapter, did you have to turn the key to on without starting the car? Thank you
@partsshooter
2 жыл бұрын
Yes, key on engine off
@daniellegreenawalt8184
2 жыл бұрын
Hi, really hoping that you can help me. I have a 2005 Toyota Sienna. I'm getting the P0500 code. I have replaced both sensors and the pigtail. Check engine light is still on. What else could it be?!
@partsshooter
2 жыл бұрын
That's a VSS code, (vehicle speed sensor) That's located on the transmission and not wheel speed sensor that's at the wheel by cv axle
@gbemisolaayinke7313
2 жыл бұрын
Pls I want to know maybe is abs that is controlling the speedometer because my speedometer is not working and the abs is faulty too pls enlighten me
@rafaelmonzon1429
3 жыл бұрын
Great video. I have a code 1603 on a 2011 Sienna. Can you guide me on what I should be looking for. Just recently replaced the O2 sensors on the Bank 2 Cat and then this code came up. Any help would be much appreciated.
@partsshooter
3 жыл бұрын
'C' or 'P' code?
@rafaelmonzon1429
3 жыл бұрын
@@partsshooter My bad didn't expect a quick answer and my phone died. Ironically 1603 went away but now its C1201. Kind of scary these codes are jumping around like that. All this after I changed my O2 sensors of bank two cat
@partsshooter
3 жыл бұрын
@@rafaelmonzon1429 try leaving the battery disconnected for a few hours, car likely just need a hard reset. This code will manifest if there's check engine light issues affecting engine performance, I guess anything that'll inhibit cruise control will cause traction control lights also and c1201 to surface. It's benign and check engine light related, code isn't specific to any isolated part
@rafaelmonzon1429
3 жыл бұрын
shooter ok cool thanks I'll try that and let you know how that goes. Thanks for your insight.🙏🏽
@Elsanti9838
Жыл бұрын
Hey bro what kind of scanner tools u have or what mark is it
@partsshooter
Жыл бұрын
I use autel products. Mk908... ms906bt... mk808 are the ones I have
@Elsanti9838
Жыл бұрын
Thanks that information brother
@josiahpizzo5844
2 жыл бұрын
So my traction control comes on randomly on my 2005 sienna fwd anyone have any advice?
@therealleonardlewis5438
2 жыл бұрын
And tips on diagnostic tool for under 500?
@partsshooter
2 жыл бұрын
That's a tough one... I have an autel mp808 as a basic spare. I'd recommend that, however it's not under 500. It's slightly over. It's bidirectional
Пікірлер: 26