Thank you for details, such as bolts fighting u all thru the last turn, & the misfit, & magnetic film.
@TinkeringNerd
2 ай бұрын
Thank you for watching!
@sulzy426
19 күн бұрын
What were the symptoms that went along with error codes? Mine is having same codes, but brakes grind when Trac is on but will stop when off after going 25-30, then vehicle lunges when accelerating
@TinkeringNerd
19 күн бұрын
@@sulzy426 it would not drive right, especially when turning slowly. Felt like it’s holding itself back. Also, on speeds above 40mph, it would start jerking and would not go over 45-50
@tonykari5124
23 күн бұрын
I had this problem & it turned out i was low on transmission fluid. Having too much trans fluid will also make this pop up once the transmission fluid gets too hot ...
@TinkeringNerd
22 күн бұрын
@@tonykari5124 did it drive smooth though? Mine was not getting above 45mph without shaking.
@rizzogangret7989
2 ай бұрын
If I may ask what was the actual message on the paper after they scanned it?
@TinkeringNerd
2 ай бұрын
@@rizzogangret7989 they don’t give you paper. The message on the screen was something like: stabilitrak system failure, rear right low possibility.
@dancurrier6421
Ай бұрын
i changed my front wheel bearings and both front wheel speed sensors and my traction control and stability lights are on the dashboard still after garage put it on there scan tool said left side wheel speed sensor I unhooked the battery left it sit for 30 minutes no luck at all
@TinkeringNerd
Ай бұрын
@dancurrier6421 sorry to hear that. Modern cars are tricky…
Пікірлер: 12