I was trial fitting mine tonight and decided to see how KZitemrs are doing it. I like your down-to-earth approach to this build. Thanks. Together we'll all complete this rifle. Mine's the percussion model .50 caliber.
@rayray3866
4 жыл бұрын
Awesome thanks for watching. I’m editing the next video in the series as we speak haha it’s been a fun build!
@jimihendrix4376
Жыл бұрын
Sad to be so picky, it takes the joy out of life! lol
@johnzeszut3170
2 жыл бұрын
Hello - could you help? Tenon pins are in the bottom of the barrel - are the pins supposed to line up along the sides? I have an old CVS kit and the quality control on this one is abysmal. The pins would have to be just about the last thing to do after bluing the barrel and staining the stock?????
@AlpineSki719
4 жыл бұрын
I would super appreciate it if you showed how you pin the barrel or at lead give an explanation. I’m stuck at that part in my build.
@rayray3866
4 жыл бұрын
Hahaha I am too. It’s all finished except for the barrel pin... (pretty nervous to do this part actually) which I will do in a future video! 👍
@AlpineSki719
4 жыл бұрын
RayRay3866 much appropriated I’m doing. Little work on it tonight and may post a vid if successful.
@AlpineSki719
4 жыл бұрын
RayRay3866 be careful. I split my stock punching in the pin into the stock. This was the worst part of the build so far. I will be able to salvage it and glue it over night then start on the stock finish. I’ll be moving on to blueing the barrel today hopefully.
@rayray3866
4 жыл бұрын
Pete Stanger ahh man that sucks! Did you drill all the way through or just the one side of the stock? The pins don’t seem long enough to go all the way through.
@AlpineSki719
4 жыл бұрын
RayRay3866 I did drill all the way through. The pins are indeed not as long as the thickness of the stock. I just used a punch to tap them in until it was even on both sides or in the middle as much as possible. I really do not like these pins haha. I glued the stock back up and I should be good to go. I know have a very slight gap between the upper and lower stock where the 2 pins and brass plate are. It’s very minimal but enough to drive me crazy haha.
@bkhammer3807
3 жыл бұрын
I had to use wood putty to build up where the fore stock meets brass end cap at the muzzle (stock came too short where the barrel holes are) I’m stuck trying to figure out barrel tenon pins! Instructions are horrible...can’t wait to see how you tackle the barrel pins. Thanks
@Barnettdan99
2 жыл бұрын
I'm stuck on the barrel tenon pins as well......
@seanowens6888
3 жыл бұрын
What site did you order this kit from?? The one I found is out of stock but I really want to get my hands on one
@sleepwalker29
2 жыл бұрын
I watched every KZitem video and no one shows how to fit the barrel. The back of the barrel sticks up past the wood where the screw goes. I figured I need to file it down and sand it.
@johnmullholand2044
Жыл бұрын
You might have a high spot in the barrel channel, or the back of the stock needs to be relieved a bit. The barrel should set right down in the channel along the whole length.
Пікірлер: 15