During this video I snaped 2 bolts off the bottom piece the the ram is connected too and then it snaped the corner off which ended my day. Will be back tomorrow.
You appear to have good control of your levers. Much better that I do of mine. Learned a quick tip in Part Two from you when you used the leg to move a log (a 'duh!' moment) Two questions: the bolt on thumb~ is it home built or bought? It is way better than the crap that I bought with the machine. Second: I slowed the video down to 25% to watch the rise/fall of your hydraulics. Your machine appears to be operating two circuits at the same time (around 3:30 in timeline) Have you upgraded the pump or adjusted the valve body or are you just damned good on the sticks? Mine goes up/down left/right or in/out one command at a time. Lifting, curling and or lateral movements at the same time will overwhelm the system and something is going to 'drop'.
@347trev
8 ай бұрын
The thumb is home made by my father inlaw and it is all stock except for a pressure gauge but never adjusted the pressure release valve on the valve bank. The pump was adjusted 1/4 turn or the side adjustment to speed up flow slightly i think it only matters when its not under load where its a 2 stage pump and thank you for the comment.
Пікірлер: 3