Yessur, anything to slow them down or go elsewhere. Thanks!
@UdellPhotographics
3 жыл бұрын
how do you smooth out the M-1 ?
@hansmeister2480
3 жыл бұрын
Make finger wet(spit/water) and push down gently like on silicone or caulk. You have to go slower and be more careful, it is more sticky. If using it for the first time, try a test first like 1 foot beed should give you the idea. Hope this helps, take care Hansmeister.
@nixsonbronson4595
2 жыл бұрын
@@hansmeister2480 Have never heard of M-1 before and am surprised at that. How does it compare to epoxy? It is a one part glue?
@hansmeister2480
2 жыл бұрын
@@nixsonbronson4595 It works better then epoxy in my opinion, for certain applications like this one. It dries into a very hard rubber but still flexible and withstands wide temperature ranges(+125 to - 30) . You can find it on ebay and amazon, but mainly sold in roofing supply stores. Roofers use this to glue flashing together and onto chimneys etc. The biggest advantage to me is that it doesn't crack like epoxy or that as used in this video you can't just take a screwdriver , chisel or crow bar and whack it of real quick. I had the "privilege" to remove a 20'" long piece of 2x4 that was glued on with this stuff and I spend 30 minutes chiseling away piece by piece, good times !! Since then I have been using it for almost about every application, see some of my other videos on my channel, I will try to upload a few more clips with different applications of this adhesive, since I'm using it in the snow as well. Hope this helps, please subscribe and click the notifications bell, thanks for watching.
Пікірлер: 7