bro i needed more detail my train still wont get AMP
@KB1285
Жыл бұрын
i figured it out you must got to each loco sit in the engineer seat the speed box will be red reset air break by move to suppress and back to handle off the follow to rest of loco then go back to main engine you will be good. basic u are releasing brakes on each cab all breaks are locked
@cliffwilkie4035
Жыл бұрын
You also have to reset the PCS (power control system) after releasing the automatic (whether emergency application was desired or undesired), in order to fully recover the air. This is accomplished by cutting out the automatic valve & then cutting it in again. When you go into emergency, the PCS will cut out, preventing the entire power consist from loading any amperage. This is a protective feature that will (theoretically) prevent the train from breaking in two or more pieces during the emergency application, especially if you’re running in a higher throttle setting, such as Run 8. You will have to reset the PCS, in order to recover the air AND to begin loading amperage again.
@cliffwilkie4035
Жыл бұрын
@@KB1285 there’s no need to go back to each trailing unit to reset anything (at least in real life). Normally releasing the automatic (& ensuring the emergency switch for the EOT on the LCU box is no longer toggled) & resetting the PCS on the lead unit is all that is needed to recover the air.
Пікірлер: 9