Found a video i haven't watched yet. Great as always brother
@EverythingHVACR
Жыл бұрын
This is an old one, thanks Jason
@americafirst6016
3 жыл бұрын
Good catch on the smoke detector, my first guess was RTRM board.
@EverythingHVACR
3 жыл бұрын
Thanks for watching!
@samyz1660
5 ай бұрын
An awesome video, add to it an ems system, which I’m looking for. If it happens to face one, please record a video.
@EverythingHVACR
5 ай бұрын
Thanks, I appreciate it. I have a controls playlist that you may be interested in.
@samyz1660
5 ай бұрын
Definitely subscribing and checking the control videos. Thx
@EverythingHVACR
5 ай бұрын
Thank you, HVAC Daily.
@praefectus6492
6 ай бұрын
Great video brother thank you
@EverythingHVACR
6 ай бұрын
Thank you, Praefectus! I appreciate it.
@CHOMAHOMA
Жыл бұрын
I liked the video. Thank you.
@EverythingHVACR
Жыл бұрын
Thank you CHOMAHOMA
@marcolanza5132
8 ай бұрын
Great video!
@EverythingHVACR
8 ай бұрын
Thanks Marco!
@johnluke4571
5 ай бұрын
This guy is great
@EverythingHVACR
5 ай бұрын
Thanks, John Luke
@scoutwar1474
Жыл бұрын
Great video.
@scoutwar1474
Жыл бұрын
Trane rtu runs for 3 minutes, compressors runs , then stops. Pressures are fine, Amps looks great for condenser fan motor and compressor. Did not run test. Any thoughts?
@EverythingHVACR
Жыл бұрын
3 minimum is key. I'd say you got a safety cutting you out, look closely at the diagram, and find all safeties. Keep in mind that a safety could be opening or closing when it's not supposed to as well. seeing a diagram would help. Time delay safeties, low pressure or oil pressure, could be freeze stat or compressor temperature sensor. Is it on controls? You need to know and verify all safeties in the compressor circuit.
@EverythingHVACR
Жыл бұрын
3 minute may be key
@scoutwar1474
Жыл бұрын
Thank you, I’ll try the safeties of the voyager II, no diagram available since the panel flew after the hurricane.
@Sc19869
9 ай бұрын
So when switch is open you should read 24 volts? And when switch closed should be zero
@EverythingHVACR
9 ай бұрын
Correct. If reading voltage on a closed switch, it's like touching your leads to the same point, so you read no voltage.
Пікірлер: 23