I created a tool with a small bolt with a 14mm head and two nuts locked together to loosen the fill bolt. Also ista does have a service function to reset TC clutch adaptations.
@DIYDime
2 ай бұрын
Nice
@BobsGT235
4 ай бұрын
The newtis service info states that a software program (ISTA) needs to be used to open the valves inside the transfer case to drain all the fluid properly. Maybe it's not needed?
@DIYDime
4 ай бұрын
I don’t know, I need to look into it. I did change without any ISTA work.
@Fab24hdumans
29 күн бұрын
If u remove a little bit but not everything and replace with the exact quantity, then doing this 2-3 times, who care about their bs program. valves will open and mix with old fluid, 2-3 times later it’s all good… no brainer ..
@paxrom1
2 ай бұрын
how much fill capacity?
@DIYDime
2 ай бұрын
1 Liter or fill until it’s running out.
@paxrom1
2 ай бұрын
@@DIYDime how did you position the straw, I can’t seem to get it past the middle part
@DIYDime
2 ай бұрын
@@paxrom1It is soft flexible hose that connected to the soap pump.
Пікірлер: 9