Well done, thank you for explaining how the ecu could think 1 wheel isn't turning with a bad sensor.
@mrfxr1695
Жыл бұрын
Thanks All the best 👍
@googleuser3760
Жыл бұрын
That is absolutely insane that a bad wheel sensor can cause the car to go into limp mode. That just blows my mind.
@mrfxr1695
Жыл бұрын
I was surprised as well
@808antgwap6
Жыл бұрын
I almost fucking passed out thinking it was my transmission 😂
@808antgwap6
Жыл бұрын
Thank God for the internet
@mrfxr1695
Жыл бұрын
@@808antgwap6 thanks God it's only a sensor😃
@deandrejack7045
Жыл бұрын
I been trying to fix my wheel speed sensor can’t get the light to go off and my car randomly goes into limp mode
@donchristianson3153
Ай бұрын
What I found was the rear cv axles , the reflectors on them were rusty and the sensors wouldn't pick up through the rust changed the axles and problem over
@mrfxr1695
Ай бұрын
That would work for sure, because by changing axles you're changing tone rings as well as they are pressed onto CV knuckle. In my case I didn't want to increase the cost by buying new axles. Bottom line, yes , changing the axles will definitely sort the issue All the best 👍🙂
@redinstrumental7535
Жыл бұрын
I have codes for both front wheel speed sensor circuit. no abs light . But i got limp mode on Gmc envoy 2004?
@mrfxr1695
Жыл бұрын
Check wiring, it's odd that both front wheel sensors would fail in same time, but it's not excluded to be sensors
@USSOBRIEN
Жыл бұрын
My fuel gauge won't move either! This is the same thing I'm going through right now! Gonna try your fix, and come back and comment if it works or not.
@mrfxr1695
Жыл бұрын
I'm not sure why your fuel gauge won't work. Your might have wiring issue. There is a possibility that rear wheel sensors cabling and fuel tank cabling are in same wiring harness
@johnfasanoii4382
Жыл бұрын
I have issues with round pegs in square holes too
@mrfxr1695
Жыл бұрын
🤣😂 sometimes you just have to hammer it in
@jamesmacdonald3090
Жыл бұрын
Mine is in limp mode, abs ring needs changing. Did your car make strange noise from the rear whilst in limp mode, bit like a grinding diff or wheel bearing?
@mrfxr1695
Жыл бұрын
No it didn't, no noise whatsoever
@jamesmacdonald3090
Жыл бұрын
@@mrfxr1695 Bugger! Probably got an issue with the diff? Long term project just got longer! Ta mucho.
@mrfxr1695
Жыл бұрын
@@jamesmacdonald3090it could be a wheel bearing or even something lodged between brake disk and deflector. I hope it will be easy fix. I wish you all the best with it
@hassanalqbain
Жыл бұрын
Hi - thank you for the video, changed the sensor. All codes are gone but the three lights are still on. Any ideas? Thank you for your help
@mrfxr1695
Жыл бұрын
Have you cleared codes with obd diagnostic tool? You'll have to run full diagnostic on abs system. There is probably a failure elswhere as well. There are four wheel sensors and abs tone rings, esp module under central console, rpm sensor, steering wheel positioning sensor and more plus all the harnesses and connectors. Try to run live data for individual sensors to try to spot anomaly I hope it helps All the best👍
@rogerlimoseth4790
Жыл бұрын
Tone ring? That parts disintegrates after some years. The tone ring has a magnetic strip that spins and allows the sensors to track wheel speed.
@jeniselynnmartinez9762
Жыл бұрын
I have this problem with my car in limp mode. Abs light was on and code P0501 . Change my tone rings , bearing and hub assembly and wheel speed sensors. My car is still in limp mode … no codes are showing right now. Any idea what else it could be?
@mrfxr1695
Жыл бұрын
Hi, it is strange to still be in limp mode after old codes were cleared and no new codes showing. Did you try to read live data, such as speed of each wheel compared to vehicle speed
@ssbluegokray4289
Жыл бұрын
Could be an axle or your gas paddle
@nick-ip6le
Жыл бұрын
Anyone figure this out? Mine is doing the same thing.
@mrfxr1695
Жыл бұрын
@@nick-ip6le you might be too get the car to someone who can read transmission codes. Transmission ecu uses wheel speed sensors to determine vehicle speed, so tone rings and wheel speed sensors have to be good. Also there are sensors on transmission box that could be faulty but not every obd reader can pick that up
@stanfordwelchut8233
Жыл бұрын
Could be ur wiring. On the 5 volts reference
@bless200645
Жыл бұрын
Nice one. Git the same issue can you help to fix. I am in london
@mrfxr1695
Жыл бұрын
Unfortunately, I can't physically help you with that. You might have to find a reputable local mechanic All the best 👍
@Awful_HeartRB
Жыл бұрын
I have the traction light and esp light but no ABS light and will it be still be the sensor and why is the engine light and flashing when I turn the ignition on
@mrfxr1695
Жыл бұрын
You'll have to run diagnostics first, there are few more sensors around the car that are part of that system
@tiffanybiffle6914
Жыл бұрын
Mine too
@ogmanman759
Ай бұрын
Did Yhu figure it out
@momjean-zq9wv
Жыл бұрын
What is that sensor cable called
@mrfxr1695
Жыл бұрын
It is abs sensor, it is different for each wheel
@calvinhoward2277
Жыл бұрын
Why are you so rough with the new sensor!? Those things are very fragile
@mrfxr1695
Жыл бұрын
They're study enough. I might look rough 😉
@joeyoung9477
Жыл бұрын
My csr went Into limp mode for a month untill I reset the throttle body. Took me 10 seconds
@mrfxr1695
Жыл бұрын
I'm glad you have sorted it 👍
@torealjackson6504
Жыл бұрын
How did you rest it
@demetriusdavis7709
Жыл бұрын
Im having the same prob , mines wont go over 30 mph and traction ct and abs light on and brake light comes on
@mrfxr1695
Жыл бұрын
Sounds same. Plug in obd reader check for codes and run life data stream on wheel speeds. The wheel that is showing 0mph speed has faulty sensor or tone ring. All the best 👍
@USSOBRIEN
Жыл бұрын
Did/Does is change out of 1st gear? Mines won't.
@mrfxr1695
Жыл бұрын
@@USSOBRIEN it didn't charge gear, it stayed in first as a limp mode
@anthonyfabbro1815
2 ай бұрын
Two transmissions later i find this video lol
@mrfxr1695
2 ай бұрын
Wait, what, you respected gearbox twice, 😯 I feel your pain
@anthonyfabbro1815
2 ай бұрын
Gonna go argue with mechanic today just went into limp mode again.
@Vatosofla
Жыл бұрын
Where can I get that sensor
@mrfxr1695
Жыл бұрын
I've got mine of eBay, it still works fine
@tracistanek6374
10 ай бұрын
Amazon had them
@mrfxr1695
Жыл бұрын
OBD reader diagnostic tool with abs function amzn.to/3LvcMUN
@LivingAbyss12
10 ай бұрын
This version does not have ABS option. Make sure to order version which has ABS option. The scanner used in the video is elite version which is different from the one shown in the link.
@mrfxr1695
10 ай бұрын
@@LivingAbyss12 thank you for highlighting the error. I've just corrected the link for version with abs. I'm not sure how wrong link was posted. Thank you again👍
Пікірлер: 59