Great job, Your video was not too long, I bought a used x max, and I too was going through it. That way, I know what what's needed. You know what is new, Motor bearings are OK, but still need to be replaced. Gonna do that this weekend.😊
@kanedavis8797
2 ай бұрын
Really appreciate the video was worried about doing this to my xmax but you make it seem simple enough
@shaneelranchod4699
8 ай бұрын
Great video 👍
@chriscottell6854
3 ай бұрын
I'm guessing this is why my motor is overheating quickly.
@jaguarsrcfamily101
Жыл бұрын
Get some better bearings asap TRB RACING 15$ completely saves the motor rotor from damage
@johngantner9314
Жыл бұрын
part numbers for those trb bearings?. Please and Thankyou
@FrankSalinas-qc5fl
6 ай бұрын
Sorry i didn't finish what I was saying can someone tell me why my motor hesitates when i full throttle it it hesitates then goes
@markkumollari43
4 ай бұрын
Have you taken the motor apart, check the bearings and internal condition?
@G35Jeesh
Жыл бұрын
My motor shaft is pulling out while running my car and my pinion stays on the shaft, just walks off the spur. Do I need to replace a bearing or something or is it shot ?
@markkumollari43
Жыл бұрын
Not to sure, you may need to take it apart and inspect. I replace the bearings in my motors annually and sometimes sooner depending on condition. Thanks for watching. Cheers 👍🇨🇦🤠
@shaneelranchod4699
8 ай бұрын
Just opened up my x maxx motor, found that there is a fishing wire type thing on the inside magnet piece that appears to be torn up. Do you know how I can get it replaced?
@markkumollari43
8 ай бұрын
If the yellow kevlar coating is tore up, you will probably need to buy a new motor. Bearings going bad usually cause this to happen. You can try cutting the loose pieces off and see if you can get a few more runs out of it. 🤷♂️ Thanks for watching. Cheers
@pointblankyt9878
Жыл бұрын
Awesome video! Do you know where I can purchase just the magnet ?
@markkumollari43
Жыл бұрын
Unfortunately not sold separately yet anyway. Thanks for watching. 👍
@pointblankyt9878
Жыл бұрын
@@markkumollari43 Thank you
@reznya2700
19 күн бұрын
Goit the 1275 1200v motor rebuild kit doesnt fit?
@markkumollari43
19 күн бұрын
I have put the kit into 1600kv and 1275kv VXL motors. Look at the rear bell end of the motor, it had will have the motor size on it.
@FrankSalinas-qc5fl
6 ай бұрын
Can someone tell me why my motor hesitates when i full
Пікірлер: 18