why di you stopped uploading you are one of the most entertaining helichannels to watch ):
@HeliMouse
10 жыл бұрын
very cool flight kudos on the dual
@RC3Dflownwithpassion
8 жыл бұрын
Very very nice!
@RattyfromInsideFPV
10 жыл бұрын
If only i was there, we could of made it a triple flight. I could hover at the end of the strip...... Nice flying.
@tomstanton28
10 жыл бұрын
Will definitely have to do that before I got back to uni!
@111zzzrrrzzz111
10 жыл бұрын
Very nice! Like!
@33gate1
10 жыл бұрын
Hi Tom, need your help please.My HV servos, used with AR7200BX, B swashplate servo Frequency? C Tail center Position, sure its 1520? And last D Tail servo Frequency? Is it 333Hz. If you could help me with those 3, would be of grate help. All the online servo lists, they do not have the HV servos. Thanks Tom.
@tomstanton28
10 жыл бұрын
Here is a link to a list of all the servo specifications: jprchelis.com/wpdir-jprchelis/wp-content/uploads/2012/11/MicroBeast-Servolist.pdf . If the link doesn't work, swashplate servo frequency is 200Hz, tail center position is 1520 and tail servo frequency is 333Hz.
@33gate1
10 жыл бұрын
Thanks ! I ended up using the DS615 and DS650 info. And thats the same as you said. Thank you for your reply!
@33gate1
10 жыл бұрын
Hello Tom, i need some help please, i bought this from your shop today, T-Rex 700E HV DFC Top Combo KX018E15T I see a video on youtube, were the guy has a micro beast x, and he talks about having 4 HV servos on the flybarless, can draw to much power, and the flybarless can cut out. I have a AR7200BX i want to use on the 700. Is this true, do i need to run power directley into about 2 servos, to not work the flybarless to hard ? I was thinking, as i do not fly hard 3D, maybe sell the 3 cyclic servos, and get 3 Align DS615, i do not want my first ever 12s, first ever trex 700 falling out of the sky. Here is a link to that video. Thanks, and cant wait to get my 700 tomorrow :) kzitem.info/news/bejne/tn5tqoFooqiIq3o
@tomstanton28
10 жыл бұрын
As far as I know, you'll be fine to power everything straight from the receiver pack (2s lipo). The only thing you MUST do is wire the power input through 2 servo connectors. This is because each servo connector is rated for 3-5A and with all those servos, it could draw more than that. I think that is the main reason for brown outs. What I have on my GPro is an EC3 connector with two servo wires soldered into it, then on the other end, the two male servo plugs go into the GPro. So the two connectors share the power input and can now take up to 6-10A. My friend, that also work there, runs beastx with HV setup on a 700 and he has never had a problem with the two servo leads going into the beastx. btw, I saw your 700 being posted, so have fun building it ;)
@33gate1
10 жыл бұрын
tomstanton28 O.K , this helps me loads. Thank you !
Пікірлер: 13