Thanks for this video. It helped me set the magneto on my '65 Atlas.
@Calvadoslash
2 жыл бұрын
Good video! You can stop the magneto armature from turning when you tighten the bolt by taking out the earthing brush holder. Remove the carbon brush and spring and fit a small wooden plug, This will stop the armature from moving while you tighten everything up. Replace the carbon brush and spring and you're done.
@dogpaw775
Жыл бұрын
Doesn't take dwell into account at TDC, also to say, bring up towards full advance to negate gear lash .
@RicardoMoreira-hj3hh
3 жыл бұрын
Hi Lorenzo! Excellent video!! Could you just please let me know the following: once you have timed the engine using the method shown in your video, then which spark plug cable (from the magneto) goes to which cylinder? Is it the one closest to the cylinder head (inner) going to the right hand side cylinder (from rider's sitting position) and the outermost one to the left? Hope you will be able to post a response.
@rytonadavies
7 жыл бұрын
Very good film and way to do it. After i have done this i bolt the engine up put a degree disk on the alternator bolt and strobe it to find out if it is right.
@rolikx23
4 жыл бұрын
how do you do it when you do not have a degree wheel but a piston stop tool (BU4936 Buzzetti)?
@VndNvwYvvSvv
5 жыл бұрын
Easy, but how do you do this on the models without a threaded hole in the crank or cam? That's the trick...
@MaryCruzHernandezSegura
6 ай бұрын
Hola soy de mexico tengo una trimp t100 del 57 me podrías ayudar con marca
@BobMontgomery-o4h
Жыл бұрын
I would like to use a test light or buzz box to time my BTH mag but have continuity with the points open and closed . Does anyone know how to properly connect a test device to the magneto ? Thanks Much !
@lorenzograssi2683
Жыл бұрын
check this my video kzitem.info/news/bejne/znmp2GuGsV-kfqQ
@TommyNissen
10 жыл бұрын
great just what i want
@steveburden1801
7 жыл бұрын
How do you attach the degree wheel? I have s 1959 Bonneville and I can't see how you can attach to the crank pinion and also clear the exhaust. Any advice Thanks.
@emmanuelgonssollin5802
7 жыл бұрын
Steve Burden g
@derekcollins9206
6 жыл бұрын
Steve Burden With a bolt and a spacer
@Calvadoslash
Жыл бұрын
I'd be interested to know how that's done.
@JamesCouch777
6 жыл бұрын
How do you keep those pipes so shiny?
@JamesCouch777
4 жыл бұрын
@ladywonderland well I started mine. I installed a gasket on the points cover to make sure that dust wouldn't get in.
@JamesCouch777
4 жыл бұрын
I saw the gasket you were talking about. I would think you would need that one or something.
Пікірлер: 20