was fuel pump priming when ignition turned on first? having similar issue
@ethanmatei9269
3 жыл бұрын
bought a e36 328i a 98' and been having a crank no start problem but I can occasionally get it to start and idle
@harrydressendorfer5008
Жыл бұрын
Did you ever find out the reason why? I’m having the same issues
@thatonearamikos3069
Жыл бұрын
Any way you fixed it? Same issue
@awankawan5093
Жыл бұрын
my 1997 e39 M52B28's new fuel pump, fuel filter, camshaft Position sensor as well crank sensor didn't help. Reused old stock camshaft. Cleaning fuel injector to spray atomize vapor brought back quick start .
@purnadika
9 ай бұрын
2:52 so that's the normal fuel pressure? Mine is not squirting that much. Maybe I have to try to replace the fuel pump and filter
@petershulick5270
2 жыл бұрын
Were you able to verify a ignition coil spark? And starter fluid to see if it would start as far as fuel deliveries concern
@Dylan_Draper
2 жыл бұрын
Yes, I eventually confirmed spark was present and fuel was being delivered (I have a few other videos following along the troubleshooting).
@WR250RONNIE
2 жыл бұрын
Hopefully you get it running man my e46 was a pain in the ass. What wheels are those though?
@Dylan_Draper
2 жыл бұрын
I did finally get it to fire over (covered in a later video in more detail). Essentially, the rings were stuck and the car had low compression.
@Dylan_Draper
2 жыл бұрын
The wheels are Mille Miglia MMII’s (17x8.5 et13). Currently have them listed for sale! (Located in PA).
@WR250RONNIE
2 жыл бұрын
@@Dylan_Draper im in jersey thats awesome to hear that it is good now we should def get a track day in one day
@aj090ful
2 жыл бұрын
Just replaced my fuel pump for no reason lol. It’s okay though bc old cars could always use fresh parts. Came out to be my Camshaft sensor and Crankshaft sensor. Replace those and then wahlaa 🪄. Ancel AD310 told me exactly what the issue was would definitely recommend to anyone
@bimmerbuds
2 жыл бұрын
What year is your E36?
@HawkEyesAndy
2 жыл бұрын
one of the first things i would check, this cars are known to have starting failures resulting from bad camshaft and crankshaft sensors
@alex_hustler
2 жыл бұрын
БМВ огонь!
@drayescobar9469
2 жыл бұрын
I have the same issue, i bought a m50 single vanos from a crashed e36 1993 and swapped it in my e30. The engine cracks but doesn’t start, fuel pump and all lights in the dash work no spark on the coils however
@hyp3r594
2 жыл бұрын
Howd u fix it
@drayescobar9469
2 жыл бұрын
@@hyp3r594 replaced the crank sensor
@onesikm3
8 ай бұрын
Usually the cam and crank sensors go out hand in hand and if it was obd2 it would have told you most likely too what the problem was.. that obd1 life trust me I know I’m living it lol
@tommcl8548
3 жыл бұрын
👍
@gamergavinfn246
2 жыл бұрын
My brothers car has compression and gas but he don't have a spark tester and no place to ground it
@Dylan_Draper
2 жыл бұрын
Remove one of the front 2 coil packs and spark plug. With the coilpack plugged in, push the spark plug against the coil pack boot and somewhere on the passenger front inner fender well (one of the top struts nuts works well if you can manage to reach it). Then crank the car over and look to see if the plug is sparking.
@Dylan_Draper
2 жыл бұрын
That’s assuming it’s an e36…
@piquantg7072
2 жыл бұрын
i have a problem with my e36,when i put the key in and rotate it all the lights come on only the oil pressure and battery light doesnt.When i hit the engine with a rubber hammer it will show every light but wont crank.It will start only when a person is hitting the engine constantly and the other person is turning the key to the run position.Anyone has a sugestion? my car is a 1991 e36 318i
@Dylan_Draper
2 жыл бұрын
Are you “hitting” it in any a specific place? It sounds to me like an issue with the starter.
@piquantg7072
2 жыл бұрын
@@Dylan_Draper im hitting it at the intake
@Dylan_Draper
2 жыл бұрын
@@piquantg7072 I would check all the wires to the starter and make sure they are on correctly and tight.
@piquantg7072
2 жыл бұрын
@@Dylan_Draper i need to change the starter,you know a good video that shows how to change it because i only saw videos that didnt explain rly well or it was another model like e46
@tobiashansen9759
2 жыл бұрын
tip use only original bmw krank sensor
@awankawan5093
Жыл бұрын
Non-BMW sensor wont even start. Went back to reuse the 25 years old sensor . Check fuel injector.
@kuljitg22
2 жыл бұрын
Hello try changing the engine computer
@Dylan_Draper
2 жыл бұрын
In a later video, I did swap in and even tested spare DME’s in another car. The culprit for this crank no start issue ended up being low compression from stuck piston rings.
@topnews1007
2 жыл бұрын
Looks like you need new coils and spark plugs, the water destroyed them Cam , exhaust and crank sensors can not be made in China also your coil packs. You have to pay to play
@Dylan_Draper
2 жыл бұрын
The main reason for not starting ended up being stuck rings, however I did have at least a dead dme at one point.
@sighsohigh
2 жыл бұрын
@@Dylan_Draper How were you able to determine this? Compression test? I would have guessed CPS, dealing with a similar issue. CPS on order
@Dylan_Draper
2 жыл бұрын
@@sighsohigh I have 3-4 more videos going through diagnostic process and showing what I did along the way
Пікірлер: 38