Anti pumping relay is in parallel to closing coil , the function of antipumping relay is to relieve the closing coil from continuous operation , closing coils are designed to sustain closing command voltage for a fraction of a second , if it is not relieved then it may burn out...
@aswajithasokan7325
4 жыл бұрын
Excellent video great presentation.. Thank you so much..
@FULLMOON36528
4 жыл бұрын
thanks...excellent video for working engineers...
@highspeedgaz
2 жыл бұрын
When fault finding on complex relay control circuits , use a voltmeter and make the 0v line had wired to one of the test leads on your volt meter, AC circuits , or Negative DC circuits ,once this has been done you are now able to check the circuit throughout using the other probe on the volt meter ., I myself start at the relay and worked back to find a live feed .
@MK-yi6ye
2 жыл бұрын
Great job.. thanks a lot.. please continue making such videos..liked and subscribed 👍
@surendrakverma555
3 жыл бұрын
Very good lecture. Thanks
@sujinsviews66
3 жыл бұрын
Good work mam. Keep to continue
@yadeshthakur6645
2 жыл бұрын
Thanks for sharing such a valuable information
@pandavjk547
3 жыл бұрын
Good explanation..👍
@seablue1085
3 жыл бұрын
amazing, thanks for video, keep it up!
@yashwantsharma9759
4 жыл бұрын
Superb mam..
@simanchalparichha331
4 жыл бұрын
Nice explanation
@aswajithasokan7325
4 жыл бұрын
Great work also.... one doubt How can we remove the closing coil.?
@sathishmekkonda6149
Жыл бұрын
Good explanation
@danielahamefulaudoma9664
3 жыл бұрын
Great job. Which video software did you use for the animation . Liked the way u inserted the multimeter.
@danielahamefulaudoma9664
3 жыл бұрын
Excellent job. Which video software did you use to make this animation? I like it.
@alobalo3796
Жыл бұрын
Great thank you
@arjunkumar-dc5cx
6 жыл бұрын
Very good video Make video on the tripping circuit
@ELECTRICALFUNDAZ
5 жыл бұрын
kzitem.info/news/bejne/qGacqY6nq2Ocioo
@sureshpasare3226
5 жыл бұрын
arjun kumar cuirkit diagam चे वाचायला शिकवा
@danielahamefulaudoma9664
3 жыл бұрын
Which software did you use for the presentation? Is it different from the software u used to make the measuring animation of the multimeter. I like it. Great job.
@tilakrajkaler2766
3 жыл бұрын
Super
@yashavanthkhanapur5935
4 жыл бұрын
if possible explain about Stelmec,C&S,popular make breaker closing n tripping sceame
Пікірлер: 35