This is a 17.5 hp B&S motor on a Troy Built Pony lawn tractor. I purchased this tractor and it was doing this. I figured it just needed a carb rebuilt on it ans that wouldnt be a problem. Well I rebuilt the carb, but I was unable to remove the idle screw because of the black cap seen in the video I point at it. After rebuilding the carb it still does the same thing. I read to remove and clean that screw because there maybe some junk in that port, but i cant remove it because it only turns about half way going either direction. If i move the choke almost closed (seen in video) it smooths outs. If I hold the governor back a little it smooths out and revs up. If you engage the blades it smooths out to and seems to run fine. I would like some help here, if somebody can. Thanks so much
Link for picture directed to Anthony Hayes: www.vapor-house...
Негізгі бет Troy Built Pony 17 HP Briggs & Stratton Governor/Idle Issues
No video
Пікірлер: 32