Disappointed, I was enjoying the content up until this point. 😬 Jointing compound on the threads… that’s a red flag that you don’t have an understanding of how a compression fitting makes a seal.
@lawton2k2
Жыл бұрын
I was the exact same.
@johnsmith-ik8il
Жыл бұрын
An olive
@lawton2k2
Жыл бұрын
@@johnsmith-ik8il well done you. That's right it's called an olive. 🌟
@God-vt2qp
Жыл бұрын
Shocking
@bassman5066
10 ай бұрын
I've seen a lot of people point out jointing compound (dope here in the US) is often used as lube on threads as opposed to a seal when there are other sealing means on the joint. I started doing it myself and do find fittings go together easier with a little lube 😉
@brianmorecombe2726
6 ай бұрын
I want to do that but i dont have a drain off valve
@ashleewainwright7877
8 ай бұрын
He must be doing that for the comments surely 😂
@Alan.Moffat
8 ай бұрын
That's never going to leak from the threads now 😂😂😂
@jonr4578
Жыл бұрын
Did u forget to put back inhibitor in the system
@purpletoo12
7 ай бұрын
Are the white slides on the cap supposed to up or down...new ro Germany and need help.
@mehmetalidunndar6030
8 ай бұрын
How you turning water off from the boiler?
@AlexRocks24-7
Жыл бұрын
Good job but Shame about the cheap replacement 😞
@johnocooper9841
8 ай бұрын
A bit around the thread 😂
@OneHitWonderChef
Жыл бұрын
Unnecessary putting compound on the thread. On olive ok
@johnsmith-ik8il
2 жыл бұрын
A plumber tried to charge me 130 to do this very thing. Needles to say I did it myself.
@bobby5634
2 жыл бұрын
That's more than reasonable what did you expect him to do it for free? Numpty
@nindes
Жыл бұрын
Probably 1 to 2 hrs plus parts what's the problem
@johnsmith-ik8il
Жыл бұрын
@@nindes it took me a few minutes: drained the system , unscrewed two nuts, replaced the part which cost me 7 pounds and tightened the nuts then topped up the system. You obviously don't know what you're talking.
@lawton2k2
Жыл бұрын
@@johnsmith-ik8il a few minutes... doubt it took you that. Anyways you never said what you did with the fresh water you filled back up with.
@johnsmith-ik8il
Жыл бұрын
@@lawton2k2 used it to heat my home.
@paulrattray8121
8 ай бұрын
Didn't need to drain the system, didn't need jointing compound. Do that on my sites and I'd kick you off the job
@RobertSmith-vw9lg
8 ай бұрын
He should have PTFE on those threads 😂😂😂😂what a lot of nonsense
@ashleewainwright7877
8 ай бұрын
No 😂 jointing compound on the olive or a few wraps of ptfe , if it doesn’t get past the olive it won’t get past the thread simples. It’s a compression fitting not a threaded insert.
Пікірлер: 36