Yesterday was the part of my built of the application of AW grease to the the reinforce gear covers (54815) and also applying super glue to the periphery of the carbon damper stays (54754). I used Microbrush superfine applicators (a very fine firm cotton swab) to apply both. The glue prevents moisture from getting into the laminates which could cause delamination. For the glue I used bsi (Bob Smith Industries) super thin ca, I poured a little out on a plastic plate and applied it with Microbrush superfine applicators. I'm doing this part of the build right now for my Godson Christmas present a Phaser Edge II. Tomorrow will be the shocks. Greetings from Melbourne Florida USA
Пікірлер: 33