Guys please , just take a cut off wheel from the tubing side and follow your line cutting from the tube side off the end, your done with both cuts in about 30 seconds . You will have 2 little cresent moons of steel when your done .
@silkyway6575
3 жыл бұрын
Lot simpler than all the complicated maths and bits of paper!
@m.f.47
5 жыл бұрын
It's better to cut the two signs vertically with a cutting disc.
@elcajoia619
5 жыл бұрын
@ 1:55 you don't show the proper method on how to transfer that mark to the other side.
@juliusgovinddemerre5439
3 жыл бұрын
Simple.. each pipe has a line inside just follow it.
@jhonyfordchannel8747
3 жыл бұрын
Thanks for tips2
@saeedalam5924
5 жыл бұрын
upload this type more videos and also guide us about elbow
@gixxertard
4 жыл бұрын
nope.
@vaseemsaifi3720
6 жыл бұрын
Aap start se end tak ki full video hindi me dala kare
@danielfausto757
5 жыл бұрын
U got it all wrong.
@petejoseph8257
5 жыл бұрын
Hole saws online like eBay are cheap do a better job than all the grinding that makes a huge mess, and a lot noise. Used tubing notchers are out there or one from Harbor Freight for$60 is a better way to go, IMO. Long cuts that bottom out the hole saw can be finished with a decent jig saw. Work smarter not harder...
Пікірлер: 12