In this video I go through the tuning process needed to get this 1984 Rover Mini with 998cc High compression motor to pass a strict emissions test.
sorry in advance for the quantity of voice overs I had to do, the quality of the video I recorded in the garage was quite poor.
This mini needed to pass an idle and 2k rpm emissions test with limits of 1.2%CO.
When I first encountered this mini, It would barely pass the test, however it would not drive properly with that state of tune.
Mike invited me to do a tuning session at his house.
The following is a recap of what happened.
I started off by checking all the ignition parts (plugs, coil, wires, etc...)
Then regapped plugs to match the power output of the coil.
Checking the ignition timing profile, found a bad curve and decided to replace the dizzy with a recurved unit that I recurved specifically for this motor.
After retesting the emisssions, it was clear that the carb was worn and there were air leaks at the throttle shafts.
I replaced the carb with a newly rebuilt HS4 Waxstat carb rebuilt by the famous @ACDodd .
With this lovely carb newly installed onto the motor, I could now proceed with adjusting the mixture to reach its optimal point. Fortunately the car was running clean enough to pass the emissions test and then some!
I did need to do custom needle profiling to correct the lean mixture issues above 2K rpms.
Once that was sorted out, Mike was able to go for a test drive and report back the results.
A very happy customer !
If you have a mini that is not running well, or are struggling with an emissions test, please get in contact with me.
If you enjoyed the video, consider subscribing for notifications on future videos.
Also, if you have ideas or comments for future videos, please let me know.
Thanks for watching!
Негізгі бет Tuning Day with 1984 Mini 998cc, Strict Emissions test!
Пікірлер: 1