Some time ago I received a request to address the whole topic of using an Antenna Analyzer to tune an Antenna Tuner. This video addresses that very topic.
I am using two different antenna tuners in this video, each representing what you might find in their respective class.
The first is a Drake MN-2000, which is designed to Impedance Match a Coaxial feed line to your transmitter.
The second is a Dentron RT-3000, which is designed to Impedance Match a random length, long wire antenna to your transmitter.
I will be demonstrating tuner each of these using both my MFJ-259C Antenna Analyzer and my VNA.
Time
Marker Descriptions
00:05 Introduction
00:45 What Antenna Tuners am I going to use?
00:53 The Drake MN-2000
01:02 The Dentron RT-3000
01:50 CAUTION #1: If lightning, STOP and Ground
02:09 CAUTION #2: Ground antenna before connecting
02:38 CAUTION #3: COMPLETELY disconnect from tuner
03:13 MFJ-259C: How to disable auto-power save.
03:58 MN-2000: Introduction
04:02 MN-2000: The Procedure
04:16 MN-2000: Set the Initial Settings
04:37 MN-2000: Set up the Measurement Instrument
04:55 MN-2000: Short the Antennas to Ground
05:12 MN-2000: Remove the short, connect antenna to the tuner
05:19 MN-2000: Connect the Measurement Instrument to the tuner
05:24 MN-2000: The tuning procedure
06:40 MN-2000: The Tuning DEMO, Antenna Analyzer
07:51 MN-2000: The Tuning DEMO, VNA
09:04 RT-3000: Introduction
09:47 RT-3000: The Procedure
09:50 RT-3000: Set the Initial Settings
10:17 RT-3000: Setup the Measurement Instrument
10:38 RT-3000: Short the Antennas to Ground
10:54 RT-3000: Remove the short, connect antenna
11:02 RT-3000: Connect the Measurement Instrument
11:08 RT-3000: The Tuning PROCEDURE
11:56 RT-3000: The Tuning DEMO, Antenna Analyzer
13:09 RT-3000: The Tuning DEMO, VNA
14:17 Final Comments and Toodle-Oots
Негізгі бет Tuning Your Antenna Tuner using an Antenna Analyzer or VNA (007d)
No video
Пікірлер: 29