Turbine Rolling criteria | Various curves X1,X2,X3,X4,X5,X6,X7 | Importance of all seven curves | Criteria for opening SV ,CV, Rolling, Synchronisation | Condition for opening for Stop Valve, CV Valve | | MS temp | MS pressure | HP Shaft temp | HP Casing temp | IP Shaft temp | Cold start up | Warm Start up | Hot start up | MAL Drain | Maximum and Minimum temp range of MS temp for a particular HPCV mid wall temperature and HP Shaft Mean temp |
#nptel
#ntpc
#thermalplant
#thermodynamics
#thermal
#damodar valley corporation
#powerplant
#npti
Негізгі бет Turbine Rolling criteria | Various curves X1-X7 | How it's work |Criteria for opening SV ,CV,Rolling
Пікірлер: 42