Awesome experimenting too..With all the different mods...
@billpfeifferjr5497
9 ай бұрын
What is the purpose of removing the spring under the accumulator piston?
@BrianSwayne
9 ай бұрын
Makes it shift harder.
@kentklassen8397
2 жыл бұрын
So what do you do with the check balls then after you do the modification to valve body and separator plate do you leave the same amount of check balls in or do you leave some out?
@BrianSwayne
2 жыл бұрын
If it's just a stock rebuild I would leave all of them in.
@inscoredbz
Жыл бұрын
Everyone is telling me that 3/16 is to big for the 1-2 shift hole. They recommend 1/8. I want firm shifts, but I don't want to break my sprag. What do you think? Which check balls do you use?
@BrianSwayne
Жыл бұрын
Go .110 to .120 and use check balls.
@KingZmex
2 жыл бұрын
If my Tranns is stock Can I do this I want harder shifts
@KingZmex
2 жыл бұрын
Would this work only 2 check balls ?
@BrianSwayne
2 жыл бұрын
Yes but have to have HD sprag
@KingZmex
2 жыл бұрын
@@BrianSwayne I do 😎
@BrianSwayne
2 жыл бұрын
Top center and middle center.
@inscoredbz
Жыл бұрын
I have a 4l80e 34 element sprag, I have mine drilled to 3/16. Which check balls should I use?
@philipcarvo3349
Жыл бұрын
Terrible camera work. Too much not in the picture.
Пікірлер: 14