If I purchase a new lathe next year, it will be this model. Its size and features are perfect for my needs. Ambrosia maple is very pretty. I like the various styles shown here.
@randysmith5403
4 жыл бұрын
Good looking lathe!!!
@shawnporter6514
3 жыл бұрын
Hey, what’s the pvc setup under the lathe?
@tylersmith9868
2 жыл бұрын
Lol it literally explains it just as it shows it
@twoblacklabs
2 жыл бұрын
@@tylersmith9868 Where in the video is it explained? I've not found that particular spot.
@michaelprusak6188
Жыл бұрын
Nice platter demo. Have you had any issues with using 3rd party tool rests? I have a new 15/24 and love its features. However, I can't tighten any of my third party tool rests onto the Laguna Banjo. Those posts appear to be 1/64" narrower than the Laguna 1" post. Any suggestions.
@BruceAUlrich
4 жыл бұрын
Good information! I'm not sure which platter I like best?
@signhouseofla1
4 жыл бұрын
I think it would be lot easier if you have Laguna SUV CNC machine. That's what I use.. :-)
@ToolMetrix
4 жыл бұрын
Great project; nice clear explanation.
@robertcornelius3514
4 жыл бұрын
I like Laguna products, but guys, those are sooo undersized legs for that lathe.
@jageo48
4 жыл бұрын
Add a shelf; then stock it with plenty of sandbags, to dampen vibration.
@stevenholton438
4 жыл бұрын
How much is that lathe in the window?!
@hassanal-mosawi6049
4 жыл бұрын
Thanks for sharing that
@shahbazkh2885
4 жыл бұрын
Very nice ☺
@finnposner1425
4 жыл бұрын
Great job Chris. I have two comments. When you did the final scraping of the outside of the platter you could have changed your gouge orientation to 45 degrees (lowering the handle) and that would have given you a shear scrape and not just a scrape. Secondly I could see that you sanded the outside at +1700 RPM which can cause minute heat cracks, but it looked like you had a pretty light touch. Slower might have been better. You are right, any day in the shop and especially turning is a good one. Keep the chips flying.
Пікірлер: 16