Anh có thể hướng dẫn rõ hơn phần thiết lập ban đầu không ạ. hoặc mô phỏng tương tự trên inventor. em đang làm một công cụ dạng như vậy nhưng đang khó khăn ở phần mô phỏng ứng suất. em cám ơn
@usmanz6030
3 жыл бұрын
Can you share the Pipe file?
@jagadishshetti6937
3 жыл бұрын
i wish this was done in abaqus cae
@mechanicalkalpana6145
3 жыл бұрын
Nice video!! can you please share the Geometry file!?
@mechanicalkalpana6145
3 жыл бұрын
@@avulashandilya9884 NO
@simpalgroup
2 жыл бұрын
I created the geometry
@simpalgroup
2 жыл бұрын
I faced errors during simulation, I think you skipped some tricks in none liner setting, am I right?
@pandianshanthakumar4163
2 жыл бұрын
Yes, correct. I also faced the same issues in my simulation.
Пікірлер: 9