Nice vid. I see the timber is left twist, which is the more weak grain twist in a tree. Just a thought from an old log builder.
@themountainraven
2 жыл бұрын
Its good to see a craftsman that cares about his work.
@fabiancanada8876
2 жыл бұрын
"What we need is a square, a level, some wedges and a wire brush...... and a 12" planer :-)) Thanks for the video (the planer is on the list :-))
@timberdoodles4647
3 жыл бұрын
Even in Square Rule its nice to get a grasp on the twist, no planning the timber but you work it at the joints via snapped lines. You can also take the twist out with out using level, just a even center beam and using your eye and shims on either end align the ends with the center beam/ level but no need to use the level. Mark off shimmed differences and mark 2" marks off a given edge, yeah that need a decent video as well. I have one but its kind of cheesy
@friendlylocal3731
Жыл бұрын
Not sure when I'm going to get a chance to start my timber frame, but I'm lucky to have a bandsaw mill (the same one I'm using to cut my timbers) so I figure I can just throw my beams back on and re-square before I cut joints. Think that'll work well?
@livelife4471
3 жыл бұрын
Informative instruction, much appreciated. Thank you.
@nowhereman7398
2 жыл бұрын
Cool hand planer, had no idea you could get one that wide.
@ireneuszzmyslo2804
Жыл бұрын
The answer is only one: Maffel😄
@joeanderson444
Жыл бұрын
I have 6 of these (5.5" x 9.5") under my ranch style 44 x 24 house running from side to center every 11 feet from front to back. The rear and center on one side of the house are twisted at the foundation and flat at the center where they meet on stacked cinder block on poured concrete. It had been suggested to me to get a 2x10 and lay it on the side and use screws to try and form the timber to the 2x10. I laugh at this and know that the 2x10 wouldn't budge the timber; it (2x10) would more and likely bend like the timber or worse, crack! Any suggestions?
@loganpatrick601
9 ай бұрын
Why can’t you just use your planer shim from the last video, but start from the middle?
@juiceman1887
Жыл бұрын
Why haven’t you made any videos recently ?
@4by4squared88
7 ай бұрын
Why don’t you just shim up one side of the planner so you only plane one side to get it flat.
Пікірлер: 13