Glad i found your video i was trying to put the spring over the whole, hadn't noticed it was going between.
@johnroberts5793
5 ай бұрын
This is technically like a loaded bomb. I was trying to load it with out piece 16 on because the curious side of me wanted to see it all tight. Yeah i cut my finger pretty bad. Curiosity stopped there and i found your video to show me the proper way to do it. Thanks for the video
@davedean57
5 ай бұрын
Happy to help - and to spare your other fingers!
@jonathandock8416
4 ай бұрын
I had the same problem... Thanks for the video!
@davedean57
4 ай бұрын
Glad it helped!
@gysgtstephenson5272
Жыл бұрын
Hi Dave! Two things: 1. How did you connect the inner spring part to the wooden center shaft? (The shaft is round, but the spring end is sort of half slotted). 2. Page 6 clearly shows the spring threaded on the outside of the wooden stops; how do you tighten the spring around them? Thanks!
@davedean57
Жыл бұрын
Thanks for asking. I puzzled on this assembly step so happy to assist! Answer 1. Piece a1 (page 5 of instructions) is split down the middle (made of 2 halves fit together) the inside end of the spring fits BETWEEN (in the seam) the two halves of piece a1. The blowup on page 6 just to the right of piece 15 kind of shows that the spring goes between the two upright pieces of a1. Push the straight/flat part of the inside of the spring between the 2 pieces. Answer 2. Yes, the first two circles (180 degrees x2 or two revolutions) of spring are inside of uprights as I show in the video then the spring is threaded outside of upright just right of the spring logo/image. After the top piece is clicked into place, hold the outer end (hook) of spring with one hand/finger and start turning the knob on underside with the other hand. Spring tightens against your finger and spring winds into (inside of) the uprights until spring is small enough that the end/hook can be slid/hooked over the upright located immediately to the left of the spring logo/icon as I try to show in the video. Then you can let spring unwind by slowly releasing knob on underside. Good luck!
@user-rp8zh6by8m
5 ай бұрын
The sprigs are to hard i broke a piece on the triceratops i was tring to figure it out for 4 hours and i cant figure it out
Пікірлер: 8