Just started an HVAC job, this was a big help. Thanks dude
@KC_Tool
Ай бұрын
That's great to hear! Good luck with the job and happy to help! Thank YOU!
@adamb50
7 ай бұрын
Thanks! That’s good to know, I never knew that and totally understand makes sense.
@KC_Tool
7 ай бұрын
Thanks for watching!
@michelleschubert5613
Ай бұрын
im confused you contradicted yourself at the 3:47 mark and soon following which one is it?
@KC_Tool
Ай бұрын
Not sure. Are you referring to straight vs offset snips?
@samanthaperez358
24 күн бұрын
Instead of just talking about it, why don't you show it? What I mean is, couldn't you grab a sheet of metal and cut a piece with all the snips? Easier than trying to explain it I say.
@KC_Tool
23 күн бұрын
Maybe easier, but much more expensive for a small company. We try our best not to use the tools that we use in our videos, especially cutters, which could show wear almost instantly. We don't want to sell anybody a tool that even looks used. And if we took that many tools out of our inventory just to show how it cuts, it would be rather costly. If you need to see it cut to understand the different cuts (I'm a visual learner, too) then I would check out the many other videos on KZitem that show the tools in use. Hope that explains it!
Пікірлер: 11