Rhino AM32 Crawler 80a ESC and Holmes-Hobbies 540-L Revolver. I love this combo. The Rhino esc is good for 8s, but it'll never see anything more than 4s from me.
@benda4208
3 ай бұрын
I’m just running 3s and that’s plenty
@tomlucasrccrawlers9108
3 ай бұрын
Oh, definitely. 3s is plenty. I ran 4s for years, probably 10-11 years ago till about 4 years ago. It was never necessary. I did like the extra wheel speed on my brushed rigs and my early outrunner rigs. 2-speeds and brushless and also the leds and winches just worked better with 3s. I run a couple of huge Holmes-Hobbies 4274S 1/8th motors that have massive 1/6th size rotor in them in a couple TRX4's....I don't think they'd stay together if I ran them on 4s. I don't think the bigger Cross Tow-Truck would handle the extra out-put that 540-L would make on 4s very long. I honestly think it has as much torque as the 4274S motors...not the horses but torque-density.
@FeralRC
3 ай бұрын
Made me think of the Stubby Bob episode of Roadkill.
@tomlucasrccrawlers9108
3 ай бұрын
Hahaha. I remember that episode. Whatever happened to that truck?
@FeralRC
3 ай бұрын
@@tomlucasrccrawlers9108 last I saw they had it under a tarp in a storage lot. It's time they brought it back.
@benda4208
3 ай бұрын
Did you change any of the gearing ? I’ll be at the hobby shop Saturday and I’ll look into the Combo your running Very impressive 👍
@tomlucasrccrawlers9108
3 ай бұрын
That's a good question. I'm pretty sure I dropped 3 teeth down from the stock pinion. That was it. And I cut a small X in the esc shrink wrap and clicked the bec up to 7.4. I checked the Cross RC servos that do the shifting of the 2-speed and diff locks, they are good for 7.4. Double check my earlier video where I actually install and test this set-up, just to make sure.
Пікірлер: 9