ULTRAFIT WinCrest EVO installation guide
1. Measure the windshield
2. Cut film
3. Remove the cap sheet
4. Clean the Windshield
5. Remove the protective layer and cut necessary length of the film
6. Lay the film on the windshield - cut off excess film once again
7. Adjust the film to the glass with hands
8. Start the installation process using a squeegee
9. Get rid of the fingers using a steam gun
10. Cut off the excess film from the edges
11. Finish up the edges using a heat gun
12. Finish the process by polishing the windshield
✨Dustless
✨Self-Healing
✨Exceptionally clear
✨Hydrophobic
✨15 min installation
Instagram / ultrafit_protection
#ULTRAFIT #ReshapeTheNorm #MoreThanJustProtection #windshieldprotection #windshieldprotectionfilm #windshield
Негізгі бет ULTRAFIT Soft type Windshield Protection Film WinCrest EVO installation guide
Пікірлер: 1