I thought this mini lathe would fall apart on the first try, but it has impressed me. I have turned over 60 different things, there will be videos later on these. The mini lathe is still just as good as new, except for a little paint that has been sanded away.
But it is very light, so I had to make this base so that it does not just jump around on the workbench. So this is the video that shows how I did this. Even though I only turn small things on this one, there is a lot of dust when you turn, so I also had to make a dust collector.
It came with a woodturning tool, but I bought an extra in five parts that for me has worked much better than the one that comes with it.
Here is a link to where you can buy these products
Mini Lathe ali.ski/6f5C0U
5 pack of turning tools ali.ski/8s6Xj
Tools I used to make the base
Drill ali.ski/Hofj5v
Table saw
Hole saw ali.ski/w99kB
Forstner bit ali.ski/LabrfT
Flat boring bit ali.ski/suNt3k
Hacksaw ali.ski/f1MXUT
Негізгі бет Тәжірибелік нұсқаулар және стиль Unboxing and Making a base for a Mini Lathe
Пікірлер