Just bought and installed the Twin Air today based on this video. It’s expensive but the fit is perfect.
@dizzlerizzle2775
3 жыл бұрын
great vid im gonna be snorkling my 2020 soon
@jnix1321
3 жыл бұрын
Very helpful...my uni does the same thing. Left about 1/8 inch gap...bought some 6x6 square rubber gasket material...going to cut it out and see if that will help...about to do sya snorkels and relocate radiator on my 07 700 kq
@catlinpondel7729
3 жыл бұрын
I also have the same thing. Thought about doing a rubber seal too... than I also started to wonder it it would let the filter sit tight against the bottom. As in you may not know, type of thing?
@jnix1321
3 жыл бұрын
@@catlinpondel7729 i ended up cutting the bottom of the filter to make it fit right then put some silicone around it
@nseric1233
2 жыл бұрын
I had a uni filter on my 2014 for 5 or 6 years before I sold it, if you dont have snorkels its great. The gap around the top is only an issue with snorkels, the little gap around the filter is higher than the stock opening.
@banshee100
Жыл бұрын
We you get ready to buy the best motormounts for thr kingquaf let me know
@rubicscube7827
Жыл бұрын
You got a deal!
@stacyrethman9532
Жыл бұрын
I did some research when i swapped my stock one out on my 2017, but NOT enough... I went with the K&N and if u think the stock or the uni is bad for fit at the top, try a K&N. Its taller yet and the colored plastic over the air filter won't sit right. I have the ability to make my own orings so i took of the gap problem but the cover still doesn't fit right. Just keep in mind K&N is worse yet, and yes i know that the gap doesn't create a filtering problem but it does allow more intake and engine noise to be heard right in front of u..
@Xtreme_Mudding_ATV
2 жыл бұрын
I have a uni never got a problem theres a trick with the uni put a little lip of waterproof greasse and no problem
@dizzlerizzle2775
3 жыл бұрын
i got a rad relocate so im gonna move the relocate forward and see if i can get three pipes the the little hole in the front plaatics
@dizzlerizzle2775
3 жыл бұрын
with the tein can you go handlebars deep with
@joerutkowsky3261
Жыл бұрын
I am wondering if the filter inside the twin air is getting pushed down enough. Because you want it to seal at the bottom. It dust gets by the top it will just get stuck in the filter. If it gets by the bottom it will get sucked into the throttle body.
@rubicscube7827
Жыл бұрын
It does fit good on the bottom side.
@joerutkowsky3261
Жыл бұрын
I guess if you put rim grease on it at the bottom. as well that would give that extra layer of protection.
Пікірлер: 17