Hi sir! one doubt why do u use through curves command for the middle portion of the spoon and swept command for the first and last portion. Can we use swept command itself for the middle portion as this portion also contains both curve and section. Please clarify
@TechDesignsantosh
3 жыл бұрын
There is difference b/n those two commands.. you can check that in my channel you will understand
@nikaalavidze
2 жыл бұрын
sweep makes one curve to flow on another, and it was needed in that case and in the middle through curves because you had two lines and there was need to create surface between them
@CK-me8dl
2 жыл бұрын
Sir after finishing the sketch how can we view the construction line
Пікірлер: 8