Thats Part 3 of the series where i show modifications and upgrades on my Elegoo Neptune 4 Pro. This time they need some additional Parts, like screws, washers, T-Nuts etc. Most of the parts should also fit the Neptune 4 Plus and 4 Max, as well as for the Neptune 3 series printer.
This videos sponsor is PCBWay.com and you can get 5$ off your first order if you want.
They are professionals in the manufacture of a wide variety of parts. So you can make your own parts without having to own the necessary machine. you can find them on
pcbway.com/g/cKBcmd By useing this link you will also get 5$ off your first order.
please like and subscribe if this video was usefull for you, it means a lot to me.
Printer im using:
Elegoo Neptune 4 Pro - and you can find it here
USA-Shop:
shareasale.com/r.cfm?b=249045...
Europa-Shop:
shareasale.com/r.cfm?b=249046...
Canada-Shop:
shareasale.com/r.cfm?b=254539...
Australia-Shop:
shareasale.com/r.cfm?b=254539...
Elegoo Neptune 4 Pro, on that (affiliate) link you can get it for 279$ (OP is 330$) at the moment, but that may change over time
-------------------------------------------------------------------------------------------------------
Patreon Links:
-------------------------------------------------------------------------------------------------------
if you want to support me, here is my patreon link: patreon.com/user?u=114885466
thank you very much :-)
-------------------------------------------------------------------------------------------------------
The Upgrades video Part 1 is here:
• Best Printable Upgrade...
The Upgrades video Part 2 is here:
• More Printable Upgrade...
Mods and Upgrades for the Elegoo Neptune (3) / 4 / Pro printer i found on thingyverse and printables.com
Here are all the Links to the Parts i used in this video:
www.thingiverse.com/thing:588... - Spoolholder with bearings by afruzu
www.thingiverse.com/thing:621... - Z axis belt tension by entasdisk
Additional parts required for the modifications shown:
Link pom wheels:
a.aliexpress.com/_m0g0NMk
link bearings for belt tensioner:
a.aliexpress.com/_mq0LmFQ
2020 M4 T-slot nuts:
a.aliexpress.com/_mMUWmF2
M4 screws:
i used Flat head screws with a length of 10mm
M4 washers:
2 per tensioner
M5 screws nuts:
from your local hardware store, you need 1 to 2 screws (30mm) for 1 or 2 Tensioners, and 2 or 4 nuts...
and no, thats not my voice, i would have a strong accent and you would not understand half of it, so i use a Voiceover made with voicemaker.in
Негізгі бет Спорт Upgrades for your Neptune Printer (Part 3)
Пікірлер: 42