12:21 I believe you're doing a mistake: The purpose of this insulating strip was to protect the old SSD's integrated circuit witch was not covered with an heatsink. Sticking it back on top of the heatsink of the new SSD makes no sense. It is even counterproductive since it will prevent the flow of air from circulating against this heatsink. Your new SSD is covered with termal pad and the heatsink, it doesn't need an extra layer to keep the warms in those pieces. It'll only reduce the effectiveness of the heatsink.
@pierrefitch
10 күн бұрын
what is the type of screw driver i need will go to hardware store to get today to open case and for the ssd screw ?
@lbennett499
2 ай бұрын
You should unplug the power cable before swapping ssd to prevent bricking your system. Follow another video as you might not be as lucky doing it this way. The cable connected too the back simply lift black tape on back cover and flick tab up to release the cable then slide metal power cable bracket up and lift power cable upwards towards you as you are looking down on it.
@zyberlock
2 ай бұрын
Your right thought about the power right after I stopped recording. 🤦♂
@zeelong1589
2 ай бұрын
Myth
@Cenkolino
2 ай бұрын
@@zeelong1589 Dito. I never unplugged the battery and I highly advice against doing that with the Ally X. Because that cable is a bitch to remove and replug in. Just be careful and avoid the hassle alltogether...
@1nfamousme210
2 ай бұрын
While I agree that disconnecting the power is good practice, probably better to just YOLO it! That battery connector is a huge PITA! I had to remove the battery to get a better angle to slide that clamp back into place.
@imross7985
2 ай бұрын
Very helpful! I was able to successfully swap mine with your video guide! I appreciate it!
@J-A-C-K-N-I-F-E
2 ай бұрын
Did you unplug power supply cable before swapping ssd??
@nickc5845
2 ай бұрын
Can this handheld take ssd's with heatsinks by chance?
Пікірлер: 11